Hotpoint CH60DPXF S Mode d'emploi télécharger pdf (Page 7)

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

Prior to installation, ensure that the local distribution conditions (nature of the gas and gas pressure) and the

adjustment conditions are compatible. The adjustment conditions for this appliance are stated on the data badge

which is fitted on the back panel.

This appliance is not designed to be connected to a combustion products evacuation device. It must be installed

and connected in accordance with current installation regulations. particular attention should be given to the relevant

requirements regarding ventilation.

MODEL NUMBERS:

Category II2H3+ (GB)

These models are set to burn NATURAL GAS (G20) at 20 mbar but can be converted for use on BUTANE (G30) at

28-30mbar or PROPANE (G31) at 37mbar with the use of the LPG conversion kit that can be obtained free of charge,

if you contact our Genuine Parts and Accessories department (see Key Contacts, back page).

GAS SAFETY (INSTALLATION & USE) REGULATIONS

It is the law that all gas appliances are installed by competent persons in accordance with the current edition of the

above regulations. It is in your interest and that of safety to ensure compliance with the law. In the UK, Gas Safe

registered installers work to safe standards of practice. The cooker must also be installed in accordance with BS

6172. Failure to install the cooker correctly could invalidate the warranty liability claims and could lead to prosecution.

LOCATION

The cooker may be located in a kitchen, kitchen/diner or a bed-sitting room, but not in a room containing a bath or

shower. The cooker must not be installed in a bed-sitting room of less than 20m

When adjusted for use on Butane (G30) or Propane (G31), the cooker must not be installed in a room or internal

space below ground level, e.g. in a basement.

PROVISION FOR VENTILATION

The room containing the cooker should have an air supply in accordance with BS 5440: Part 2.

The room must have an opening window or equivalent; some rooms may also require a permanent vent. If the room

has a volume between 5 and 10m

, it will require an air vent of 50cm

effective area unless it has a door which opens

directly to outside. If the room has a volume of less than 5m

, it will require an air vent of 100cm

effective area. If

there are other fuel burning appliances in the same room, BS 5440: Part 2 should be consulted to determine air vent

requirements.

INSTALLATION INSTRUCTIONS

CH60DTXF S CH60DPCF S CH60DPXF S CH60DTCF S

Safety Chain

! In order

to prevent

accidental

tipping of the

appliance, for

example by

a child clim-

bing onto the

oven door, the

supplied safety

chain MUST be

installed!

The cooker is fitted with a safety chain to be fixed by

means of a screw (not supplied with the cooker) to

the wall behind the appliance, at the same height as

the chain is attached to the appliance.

Choose the screw and the screw anchor according

to the type of material of the wall behind the applian-

ce. If the head of the screw has a diameter smaller

than 9mm, a washer should be used. Concrete wall

requires the screw of at least 8mm of diameter, and

60mm of length.

Ensure that the chain is fixed to the rear wall of the

cooker and to the wall, as shown in figure, so that

after installation it is tensioned and parallel to the

ground level.

1 2 3 4 5 6 7 8 9 10 11 12 ... 39 40

Commentaires sur ces manuels

Pas de commentaire

Hotpoint CH60DPXF S Mode d'emploi Page 7

Commentaires sur ces manuels