Hotpoint CPDO110 X AUS Mode d'emploi télécharger pdf (Page 15)

AUS

When you first switch on the appliance you will be

prompted to set the Time of Day on the display.

You must ensure you have done this before

attempting to use the automatic cooking feature.

AUTOMATIC COOKING

The 1st oven can be controlled automatically.

HINTS ON AUTOMATIC COOKING

- Select food which will require the same cooking

time and temperature.

- To ensure food does not cool down and require

reheating, set the end time so the food is ready

when you require it.

- Always ensure that meat and poultry is defrosted

before placing in the oven.

- Whenever possible, take food out of the

refrigerator and keep it as cool as possible.

- If cooking food that requires frying before placing

in the oven for automatic cooking, keep the delay

time to a minimum.

- Never place hot or warm food in the oven for

delayed start cooking as it could cause the oven

to be warm and produce harmful bacteria in the

food.

- We advise that dishes containing left-over cooked

poultry and meat, eg. shepherds pie, should not

be cooked automatically if there is to be a delay

period.

- Ensure that delay start times are kept to a

minimum to prevent bacterial growth in food.

- Wine or beer may ferment and cream may curdle

during the delay period, so it is best to add these

ingredients just before serving.

- Foods which discolour should be protected by

coating in fat or tossing in water to which lemon

juice has been added, prior to placing food in the

oven.

- Dishes containing liquid should not be filled too

full to prevent boiling over.

- Food should be well sealed (but not airtight) in a

container to prevent the loss of liquid during

cooking. Aluminium foil gives a good seal.

- Always ensure that food is piping hot and cooked

thoroughly before serving.

- Only reheat food once.

SETTING THE TIME OF DAY:

Electronic Clock &

Automatic Cooking Feature

STEP 1. Check the electricity supply to the cooker

is turned on.

STEP 2. When switched on the display will show

both 00:00 and the set time symbol flashing. Wait

until these stop flashing.

STEP 3. Press the Time/Mode button once, so that

the Set Time symbol and the display are flashing.

Turn the +/- control knob until the correct hour is set.

STEP 4. Press the Time/Mode button once, so that

the Set Time symbol and the display are flashing.

Turn the +/- control knob until the correct minutes are

set. Press the Time/Mode button again.

TIME OF DAY IS NOW SET.

To alter the time of day after the first setting, simply

press the Time/Mode button.

The Set Time symbol and the display will flash.

Repeat STEPS 3 and 4.

SETTING THE TIME MINUTE MINDER:

STEP 1. Press the Time/Mode button, until the bell

symbol is flashing.

STEP 2. Turn the +/- control knob to set the duration

in minute increments until the required time is set.

After a few seconds the bell symbol will stop

flashing and the time will count down.

THE MINUTE MINDER IS NOW SET.

At the end of the set time an audible tone will be

heard and the bell symbol will go out. After a few

seconds the audible tone will stop and after a few

seconds the display will revert back to the time of

day. The minute minder can be cancelled at any

time by following

STEPS 1 and 2, setting the time period to zero

using the +/- control knob.

The display will revert back to the time of day. The

display shows HOURS and MINUTES

eg. 1 hour 38 minutes

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Hotpoint CPDO110 X AUS Mode d'emploi Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Barbecues et grillades Hotpoint CPDO110 X AUS