Hotpoint CPDO110 X AUS Mode d'emploi télécharger pdf (Page 26)

AUS

Service Details

To check or replace the ignition module

Electrical componentry and the electronic ignition

pack are primarily located at the rear of the Upright

Cooker. Removal of the back panel is

straightforward.

 IMPORTANT: First ensure that gas and electrical

power are disconnected before performing any

service to this appliance.

 Using a Philips Head screwdriver remove the

eight screws on the perimeter of the rear panel.

 Then remove the rear panel. Replacement is a

reversal of the above procedure.

 Care must be taken to ensure that no damage

occurs to the spark ignition leads or the igniters.

Assembly is a reversal of the above procedure.

Service schedule

To keep your cooker running smoothly, we

recommend that you have your cooker serviced

every 5 years by an authorised service agent.

Never use unauthorised technicians and never

accept replacement parts which are not original.

To check or replace the gas controls and

gas manifold

Removal of the gas manifold is initially

accomplished by removing the control knobs, the

trivets, the burner caps and burner head assemblies

and skirts.

 IMPORTANT: First ensure that gas and electrical

power are disconnected before performing any

service to this appliance.

 Using a Philips Head screwdriver remove the

control panel securing screws and then remove

the control panel. Care must be taken to ensure

that no damage occurs to the spark ignition leads

or the igniters.

 Disconnect all ancillary gas piping.

 Remove the two screws on each side of the

control panel that locates the gas manifold to the

side panels. The gas manifold may then be

extracted.

Replacement is a reversal of the above procedure.

ALWAYS PERFORM A LEAK CHECK AFTER

PERFORMING ANY SERVICE ON THE GAS

COMPONENTS OF THIS COOKER. Correct

procedure is described in the

post-installation

checks.

Service and spare parts are available on the

numbers below. Please have the following

information handy:

 The appliance model (Mod.).

 The serial number (S/N).

This information can be found on the data plate

located on the appliance and/or on the packaging.

ARISTON

PRIORITY SERVICE

If you are not completely satisfied with your appliance

or require service call:

Australia

Phone: 1300 815 589

New Zealand

Phone: (09) 306 1020

AUSTRALIA

ARISIT PTY LIMITED

40-44 Mark Anthony Drive, Dandenong South,

VIC 3175, Australia

Fax: Service & Sales (03) 9768 0838

Email: [email protected]

GENUINE ACCESSORIES

& SPARE PARTS

A wide range of genuine

accessories are available for your appliance call:

Australia

Phone: 03 9768 0888

New Zealand

Phone: (09) 306 1020

NEW ZEALAND

ARISIT PTY LIMITED

PO Box 68-140 Newton, Auckland

1145, New Zealand

Fax: (09) 302 0077

Email: sales@aristonappliances.co.nz

1 2 ... 21 22 23 24 25 26 27 28

Commentaires sur ces manuels

Pas de commentaire

Hotpoint CPDO110 X AUS Mode d'emploi Page 26

Commentaires sur ces manuels

Produits connexes et manuels pour Barbecues et grillades Hotpoint CPDO110 X AUS