Hotpoint CM 7945 IX A Mode d'emploi

CM 9945 HA

10Cleaning and maintenanceWARNING: Ensure that the appliance is switched off and disconnectedfrom the power supply before performing any cleaning or m

Built-in installationCheck the minimum measurements required for correct installation of the appliance.The coffee machine must be installed in a colum

12Secure the power supply cable with the clipprovided. The power supply cable must be longenough to allow the machine to be removed fromthe housing in

13ApplianceSee image A on page 4.A1Cup trayA2Service doorA3Coffee feedA4Coffee grounds containerA5Brewing unitA6Cup tray lightsA7On/stand-by buttonA8C

• Coffee has been used to factory test the machine and it is therefore completely normal for there tobe traces of coffee in the mill.• Customize water

151. The machine is factory-set to make coffee with a standard taste. You can choose coffee with thefollowing tastes: extra-mild, mild, standard, stro

16The appliance is factory-set to automatically deliver the following amounts of coffee:• Espresso,• Small cup,• Medium cup,• Large cup,• Mug.To modif

17• Always check that the machine is ready for use.• Check that the water spout is attached to the nozzle (Figure 6).• Place a container under the spo

18N.B.:•While making cappuccino, you can stop frothed milk or coffee run-off by pressing the button(B10).• To keep the milk frother hygienically clean

Setting the languageTo change the display language, proceed as follows:• Press the MENU button (B2) to access the menu and then buttons (B5) and (B6

Setting water hardnessIf desired, the interval between descaling cycles can be increased so that descaling is performed lessfrequently and in accordan

Energy saving• Press the icon (B2) to enter the settings menu.• Press the icons (B5) and (B6) until ENERGY SAVING is displayed.• Press the icon (B7

22Cleaning the drip trayIf the drip tray is not emptied, the water can overflow. This candamage the machine.The drip tray has a water level indicator

23N.B.: If you encounter difficulty inserting the brewing unit, before inserting it adapt it to the right sizeby pressing it forcefully from both the

Displayed messages24DISPLAYED MESSAGE POSSIBLE CAUSE REMEDYFILL TANK!- The water tank is empty orincorrectly positioned.- Fill the tank with water and

Troubleshooting25Below is a list of some possible malfunctions.If the problem cannot be resolved as described, contact After-sales Service.PROBLEM POS

400010867023APrinted in Italy10/2017GB

Instructions for use 7

4ABC

5

6

Safety instructions 8Safeguarding the environment 10Built-in installation 11Product description 13Technical data 13Using the appliance for the first t

Safety instructions8Important to be read and observedBefore using the appliance, read these safety instructions. Keep themnearby for future reference.

farm houses; by clients in hotels, motels, bed & breakfast and otherresidential environments.This appliance is not for professional use. Do not us