Hotpoint CM 7945 IX A Mode d'emploi télécharger pdf (Page 11)

Built-in installation

Check the minimum measurements required for correct installation of the appliance.

The coffee machine must be installed in a column unit, which must in turn be securely fixed to the wall

by means of commercial brackets.

Attention:

• Disconnect the appliance from the mains before carrying out any installation work or servicing.

• Kitchen units in contact with the appliance must be heat resistant (min. 65°C).

• To ensure adequate ventilation, provide an opening on the bottom of the housing (see dimensions

in Figure).

Dimensions in mm

Position the runners on the sides of the housing,

as shown in the Figure. Secure the runners with

the screws supplied, then pull them out to full

extension. If the coffee machine is installed above

a "warmer drawer", use the top of the latter as a

reference for positioning the runners. In this case,

there will be no support surface.

x 16 x 2

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Pas de commentaire

Hotpoint CM 7945 IX A Mode d'emploi Page 11