Hotpoint CM 7945 IX A Mode d'emploi télécharger pdf (Page 22)

Cleaning the drip tray

If the drip tray is not emptied, the water can overflow. This can

damage the machine.

The drip tray has a water level indicator in the form of a red float (Figure 27).

Empty and clean the drip tray before the red float protrudes from the cup tray.

To remove the drip tray:

1. Open the service door (Figure 16).

2. Remove the drip tray and the coffee grounds container (Figure 17).

3. Clean the drip tray and the grounds container (A4).

4. Fit the drip tray and the coffee grounds container back in place (A4).

5. Close the service door.

Cleaning the water tank

1. Clean the water tank (A12) regularly (about once a month) with a damp cloth and a little mild

detergent.

2. Take care to remove all traces of detergent.

Cleaning the spouts

1. Clean the spouts regularly, using a sponge (Figure 28).

2. Check regularly that the holes in the coffee spout are not blocked. If necessary, remove coffee

deposits with a toothpick (Figure 26).

Cleaning the pre-ground coffee feed funnel

Check regularly (about once a month) that the feed funnel for pre-ground coffee is not blocked (Figure

20).

Before any cleaning operation, switch the machine off using the

main switch (A23) and unplug it from the mains.

Never immerse the coffee machine in water.

Cleaning the inside of the machine

1. Check regularly (about once a week) that the inside of the machine is not dirty. If necessary, remove

coffee deposits with a sponge.

2. Remove any residues with a vacuum cleaner (Figure 29).

Cleaning the brewing unit

The brewing unit must be cleaned at least once a month.

The brewing unit (A5) cannot be removed while the appliance is

switched on. Do not attempt to use force to remove the brewing

unit.

1. Make sure that the machine is properly switched off (see SWITCHING OFF THE APPLIANCE).

2. Open the service door (Figure 16).

3. Remove the drip tray and the coffee grounds container (Figure 17).

4. Press the two red release buttons inwards and at the same time extract the brewing unit (Figure 30).

N.B.: Clean the brewing unit without any detergent since the inside of the piston is treated with

lubricant which detergent would remove.

5. Soak the brewing unit in water for about 5 minutes, then rinse.

6. After cleaning, re-insert the brewing unit (A5) so that the support and the pin at the bottom are fully

engaged; then push the PUSH symbol until it clicks into place.

A. Support

B. Pin

WARNING:

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28

Commentaires sur ces manuels

Pas de commentaire

Hotpoint CM 7945 IX A Mode d'emploi Page 22

Commentaires sur ces manuels

Produits connexes et manuels pour Cafetières Hotpoint CM 7945 IX A