Hotpoint CM 7945 IX A Mode d'emploi Page 24

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 28
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 23
Displayed messages
24
DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY
FILL TANK!
- The water tank is empty or
incorrectly positioned.
- Fill the tank with water and/or insert
it correctly, pushing it as far as it will
go.
GROUND TOO FINE ADJUST
MILL!
INSERT WATER SPOUT AND
PRESS .
- The ground is too fine so the
coffee runs off too slowly.
- Turn the grinding adjustment knob
one click towards number 7.
GROUND TOO FINE ADJUST
MILL!
(alternating with)
PRESS
(and then)
FILL TANK!
- The tank was removed during
run-off.
- There is air in the hydraulic
circuit.
- Replace the tank and press (B7).
The display shows HOT
WATER. The machine runs off hot
water and is then ready for use again.
EMPTY GROUNDS CONTAINER !
- The coffee grounds container
(A4) is full or more than three
days have passed since the last
run-off (this operation ensures
the machine remains
hygienically clean).
- Empty and clean the grounds
container, then replace it.
IMPORTANT: when removing the
drip tray, the grounds container
MUST be emptied, even if it is not
completely full. If this is not done,
when you make the next coffees, the
grounds container may fill up more
than expected and clog the machine.
INSERT GROUNDS
CONTAINER!
- After cleaning, the grounds
container has not been replaced.
- Open the service door and insert the
grounds container.
ADD GROUND COFFEE!
- The "pre-ground coffee" function
has been selected without
placing any pre-ground coffee in
the funnel.
- The funnel (A21) is blocked.
- Slide the machine out and, using the
funnel, add pre-ground coffee.
- Carefully use a knife to clear the
funnel as described in paragraph
Cleaning the pre-ground coffee feed
funnel.
DESCALE!
(alternating with)
MEDIUM CUP STANDARD
TASTE
- Indicates that descaling must be
carried out.
- The descaling programme must be
carried out as soon as possible,
following instructions described in
paragraph DESCALING.
LESS COFFEE!
- Too much coffee has been used.
- Select a milder taste or reduce the
quantity of ground coffee, then run
off the coffee again.
FILL BEANS CONTAINER!
- The coffee beans have run out. - Fill the beans container.
INSERT INFUSER ASSEMBLY!
- The brewing unit has not been
replaced after cleaning.
- Insert the brewing unit as described
in paragraph Cleaning the brewing
unit.
CLOSE DOOR!
- The service door is open. - Close the service door.
GENERAL ALARM!
- The inside of the appliance is
very dirty.
- Clean the inside of the appliance
thoroughly, as described in chapter
CLEANING AND MAINTENANCE. If the
message is still displayed after
cleaning, contact a service centre.
Vue de la page 23
1 2 ... 19 20 21 22 23 24 25 26 27 28

Commentaires sur ces manuels

Pas de commentaire