Hotpoint CM 9945 H Mode d'emploi télécharger pdf (Page 11)

Built-in installation

Check the minimum measurements required for correct installation of the appliance.

The coffee machine must be installed in a column unit, which must in turn be securely fixed to

the wall by means of commercial brackets.

Attention:

• Disconnect the appliance from the mains before carrying out any installation work or

servicing.

• Kitchen units in contact with the appliance must be heat resistant (min. 65°C).

• To ensure adequate ventilation, provide an opening on the bottom of the housing (see

dimensions in Figure).

Dimensions in mm

455

595

398

361

528

372

450 + 2 mm

500

560 + 8

Position the runners on the sides of the housing, as

shown in the Figure. Secure the runners with the

screws supplied, then pull them out to full extension.

If the coffee machine is installed above a "warmer

drawer", use the top of the latter as a reference for

positioning the runners. In this case, there will be no

support surface.

x 16 x 2

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Pas de commentaire

Hotpoint CM 9945 H Mode d'emploi Page 11