Hotpoint CM 9945 H Mode d'emploi Page 14

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 28
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 13
14
Using the appliance for the rst time
Coffee has been used to factory test the machine and it is therefore completely normal for
there to be traces of coffee in the mill.
Customize water hardness as soon as possible, following the instructions in paragraph Setting
water hardness.
1. Connect the appliance to the mains electricity supply and place the main switch (A23) in
positionI.
2. The appliance displays “fill tank” in different languages. Extract the water tank (fig. 4), rinse
and fill with fresh water without exceeding the MAX line. Replace and push as far as it will go.
3. Choose the language (the languages scroll through at intervals of about 3 seconds): When
the message “PRESS
TO INSTALL ENGLISH” is displayed, press the (B7) (Figure 3) for
3 seconds until ENGLISH INSTALLED is displayed. If you set the wrong language, follow the
instructions in the “Setting the language” section. If your language is not available, select one
from those displayed (the instructions refer to English). Then follow the instructions displayed.
4. Place a cup under the hot water spout (fig. 5). (If the hot water spout is not inserted, the
appliance displays INSERT WATER SPOUT! Attach the spout as shown in figure 6. The machine
displays HOT WATER PRESS . Press the (B7), a little water comes out of the spout.
5. The display shows TURNING OFF. PLEASE WAIT and switches off.
6. Slide the machine out, using the handles provided (Figure 7); open the lid, fill the coffee bean
container, then close the lid and push the machine back into the housing.
The coffee machine is now ready for normal use.
Never place pre-ground coffee, freeze-dried coffee,
caramelized coffee or foreign objects in the container, as they
could damage the machine
N.B.:
When using the appliance for the first time, you need to make 4/5 cups of coffee and
4/5cappuccinos before the appliance gives good results.
Each time the machine is turned on using the main ON/OFF switch (A23) it runs the
SELFDIAGNOSIS function and then switches off: to switch back on again, press the (A7) on/
stand-by button (Figure 1).
Switching on and preheating
Each time the machine is switched on, it performs an automatic preheat and rinse cycle which
cannot be interrupted. The machine is ready for use only after completion of this cycle.
Risk of burns! During rinsing, some hot water is run off from the
coffee spouts.
To switch the appliance on, press the (A7) on/stand-by button (Figure 1): the display shows
HEATING UP. PLEASE WAIT.... After heating, the display shows another message: RINSING. The
machine is at working temperature when the display shows MEDIUM CUP STANDARD TASTE.
WARNING
WARNING
Vue de la page 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Commentaires sur ces manuels

Pas de commentaire