Hotpoint CM 9945 H Mode d'emploi télécharger pdf (Page 21)

Energy saving

• Press the icon

(B2) to enter the settings menu.

• Press the icons (B5) and (B6) until ENERGY SAVING is displayed.

• Press the icon (B7) DISABLE? is displayed (or ENABLE? if the function has already been

disabled).

• Press the icon (B7) to enable or disable the function or the icon (B2) to exit the menu.

Statistics

This function enables you to view the machine statistics. To view them, proceed as follows:

• Press the MENU button

(B2) to access the menu and then buttons (B5) and (B6)

until the machine shows the message STATISTICS.

• Press (B7).

• Press buttons (B5) and (B6) to verify:

- how many coffees and cappuccinos have been made;

- how many times the machine has been descaled;

- the total number of litres of water run off.

• Press the MENU button

(B2) once to exit the function, or press MENU button (B2)

twice to exit the menu.

Setting the tone

This function enables you to activate or deactivate an acoustic signal emitted by the machine

each time a button is pressed and each time the accessories are inserted/removed.

N.B.: the machine is factory set with the acoustic signal activated.

• Press the MENU button (B2) to access the menu and then buttons (B5) and (B6) until

the display shows the message BEEP.

• Press (B7). The display shows the message BEEP DISABLE?

• Press (B7) to deactivate the acoustic signal.

• Press the MENU button (B2) to exit the menu.

Programming coffee

For instructions on programming coffee, refer to chapter CHANGING THE AMOUNT OF COFFEE IN

THE CUP.

Programming cappuccino

For instructions on programming cappuccino, see chapter CHANGING THE AMOUNT OF MILK AND

COFFEE FOR CAPPUCCINO.

Cleaning and maintenance

Cleaning the machine

Do not use solvents or abrasive detergents to clean the machine. A soft damp cloth will suffice.

The following machine parts must be cleaned regularly:

• Coffee grounds container (A4).

• Drip tray (A14).

• Water tank (A12).

• Coffee spouts (A13).

• Feed funnel for adding pre-ground coffee (A21).

• The inside of the machine, accessed from the service door (A2).

• The brewing unit (A5).

Cleaning the coffee grounds container

When the display shows the message EMPTY GROUNDS CONTAINER!, empty and clean the

grounds container. To clean, proceed as follows:

• Open the service door on the front of the machine (Figure 16), next remove the drip tray

(Figure 17), and clean it.

• Clean the coffee grounds container thoroughly.

N.B.: When removing the drip tray, the grounds container MUST be emptied.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

Commentaires sur ces manuels

Pas de commentaire

Hotpoint CM 9945 H Mode d'emploi Page 21

Commentaires sur ces manuels