Hotpoint CM 9945 H Mode d'emploi télécharger pdf (Page 23)

N.B.: If you encounter difficulty inserting the brewing unit, before inserting it adapt it to the right

size by pressing it forcefully from both the bottom and top simultaneously as shown in the figure.

Once inserted, make sure the two red buttons have clicked out.

Replace the drip tray and coffee grounds container.

9. Close the service door.

Cleaning the milk container

Always clean the tubes inside the milk container (C) after

preparing milk.

If there is still milk in the container, do not leave it out of the refrigerator for longer than is strictly

necessary.

Clean the container each time you prepare milk as described at point 3 in chapter MAKING

CAPPUCCINO.

All the components can be washed in the dishwasher, as long as they are placed in the top rack.

1. Turn the milk container lid clockwise and remove it.

2. Remove the milk spout and intake tube.

A. Milk spout

B. Intake tube

C. Groove

D. Pointer

E. Hole

3. Remove the pointer by pulling it outwards.

4. Wash all the components thoroughly with hot water and mild detergent. Make sure there is

no milk residue left inside the holes or the groove on the fine end of the pointer.

5. Check that the intake tube and spout are not clogged with milk residue.

6. Replace the pointer, milk spout and intake tube.

7. Replace the milk container lid.

Switching o the appliance

Each time the appliance is switched off, it performs an automatic rinse which cannot be interrupted.

During rinsing, some hot water is run off from the coffee

spouts. Avoid contact with splashes of water. To switch the

appliance off, press the on/stand-by button (A7). The appliance

performs a rinse cycle and then switches off.

N.B.: in the event of prolonged disuse, press the ON/OFF button (A23), on the side of the

machine, in position 0.

WARNING

1 2 ... 18 19 20 21 22 23 24 25 26 27 28

Pas de commentaire

Hotpoint CM 9945 H Mode d'emploi Page 23