Hotpoint CM HPC HB0 H Mode d'emploi Page 15

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 72
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 14
hotpoint.eu
17
en
removed as soon as the compartment is
opened. If the coffee capsule does not t into
the compartment easily, remove it and re-
place it correctly.
D4
Insert the coffee capsule as shown in the
Figure.
D5
Lower the movable section of the machine
head completely.
D6
Press the lever (1) until it locks in place and
put the cup on the cup holder (7).
D7
Touch one button:
- button 5.1 for espresso coffee delivery.
- button 5.2 for lungo coffee delivery.
The delivery will stop automatically as soon as the
set volume is reached in the cup.
The quantity of coffee poured out by
each button was determined after
carefully considering the requirements of
most users. To adjust the coffee delivery by
the different buttons based on your own taste
just follow the instructions in the next
paragraph.
The capsules are single-dose and should
not be used to make two coffees.
Remember to clean the drip tray (8) and to
empty the used-capsule tray (6). Remember to
replace the water in the tank on a regular
basis.
ADJUSTING THE QUANTITY
OF COFFEE IN THE CUP
The machine allows you to adjust the desired
quantity/volume of coffee in the small cup for the
buttons 5.1 and the cappuccino cup for 5.2.
We will only see how you can set button
5.1. To set button 5.2 just follow the
same procedure, but press button 5.2 and use
a properly-sized cup.
To adjust and store in memory a custom
quantity of coffee, the procedure is the following:
Insert one capsule in the compartment (2).
environment and reduce power consumption when
not in use. It automatically enters into Power-Save
mode if it has not been used for 60 minutes.
Button 5.1 will start ashing slowly.
To start the machine again, touch one of the two
buttons.
Before switching off the machine, we
recommend pouring out a cup of hot
water with no capsules in the capsule
compartment (2).
To switch it off set the main switch (10) to
the “0” position. We recommend that
you never unplug the machine while it is on.
POSITIONING THE CUP
HOLDER (C)
The machine was designed to use both espresso
cups and mugs.
C1
To adjust the height of the cup holder (7),
pull it out and then place it in the espresso cup or
mug position.
C2
Optimum position for mugs as suitable for
lungo coffees.
C3
Optimum position for cups as suitable for
espresso coffees.
Adjust the height of the cup holder (7)
before starting coffee delivery.
COFFEE MAKING (D)
D1
This machine was designed to use only
“Metodo Iperespresso” Illy coffee capsules.
Do not use other coffee capsules
because they may damage the machine.
D2
Make sure buttons 5.1 and 5.2 are lit (xed
light).
D3
Release and lift the opening lever (1) of the
capsule compartment (2).
If there is a coffee capsule in the
compartment (2), it will be automatically
Vue de la page 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 71 72

Commentaires sur ces manuels

Pas de commentaire