Hotpoint AKR 890 IX Mode d'emploi Page 6

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 6
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 5
5019 318 33199
8
IF NL EGB
1. Control panel
2. Grease filter
3. Grease filter release handle
4. Halogen bulb
5. Steam deflector
6. Neon light (only certain models)
7. Air outlet
Steam deflector (Fig. 2)
The steam deflector must always be left closed, and should only
be opened to carry out maintenance (e.g. Cleaning or changing
the filters).
Opening the steam deflector:
To open the steam deflector, pull the bottom part (the pins at the
centre will disconnect-A), lift the deflector slightly (B) to allow
the side pins to come out of their slots (X) To fit and close,
proceed in reverse order.
Grease filter
This should be washed once a month either by hand or in a
dishwasher at a low temperature and with short cycle.
Cleaning in a dishwasher may cause the metal grease filter to
discolour, but htis in no way affects its filtering efficiency.
To remove the grease filter - Fig. 3
Remove the steam deflector.
Pull the handle downwards and extract the filter.
Carbon filter (filter version only)
Retains any unpleasant odours produced during cooking.
The carbon filter can be washed every two months in hot water
and a suitable detergent or in a dishwasher at 65°C (when
washing in a dishwasher, run a complete cycle without any
dishes).
Remove excess water without damaging the filter, then remove
the wadding within the plastic frame and put it in the oven at
100°C for 10 minutes to dry it out completely.
Replace the wadding every 3 years or whenever it is seen to be
damaged.
•Assembly - Fig. 4
Remove the steam deflector and take out the grease filter.
Install the carbon filter behind the grease filter and fasten
with two fixing elements.
Warning! The fixing elements are included in the carbon
filter pack, not with the hood.
To remove the filter, proceed in reverse order.
Changing lamps
Disconnect the hood from the mains power supply.
WARNING: Wear gloves.
Before doing so, check that the lamps have cooled down.
Halogen lamps (detail No. 4): press at the point marked PUSH,
open, remove the old lamp and replace it with another that has
the same characteristics. Caution: the halogen lighting unit must
be opened completely, otherwise it will not close again.
Neon lamp (detail No. 6): open the lighting unit by unfastening
the 2 screws and change the neon lamp (only certain models).
If the lamps are not working, check that they are fitted
properly in place before contacting the After Sales
Service.
CONTROL PANEL
Light switch: press rapidly for partial lighting, twice for full
lighting. Press again to turn the lights off.
Press and hold, for at least two seconds, to turn the secondary
lighting system on; press again for one second to turn it off.
Motor switch: Press to turn the hood on and off. Once it
has been turne on, the hood will operate at the speed selected
previously.
Speed 1.
Speed 2.
Speed 3.
Intensive speed: maintains intensive speed for 5 minutes,
after which the hood returns to the speed set previously.
Timer: press to use the following timer functions:
Speed 1 for 20 minutes.
Speed 2 for 15 minutes.
Speed 3 for 10 minutes.
Intensive speed for 5 minutes.
When the timer function expires the hood switches itself off.
Press or to come out of the function.
Cleaning the hood
Always wait until the hood has cooled down before
cleaning it!
Warning! Failure to remove oil and grease (at least once a
month) could lead to fire.
Use a soft cloth with a neutral detergent. Never use abrasive
substances or alcohol.
BEFORE USING THE HOOD
Please read these instructions carefully and keep them for future
reference, in order to ensure best use of your hood.
Packaging materials can be dangerous for children. Keep
packaging materials (plastic bags, polystyrene, etc.) well out of
their reach.
Make sure the hood has not been damaged during transport.
Installation and electrical connections must be carried out by a
qualified technician in compliance with the current local
regulations.
Fig.1
Fig.2
Fig.3
Fig.4
Vue de la page 5
1 2 3 4 5 6

Commentaires sur ces manuels

Pas de commentaire