Hotpoint HCT 64 F L SS Guide de l'utilisateur

Naviguer en ligne ou télécharger Guide de l'utilisateur pour Hottes de cuisine Hotpoint HCT 64 F L SS. Hotpoint HCT 64 F L SS Setup and user guide [fr] Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 2
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté4.9 / 5. Basé sur5 avis des utilisateurs
Vue de la page 0
EN
Quick guide
THANK YOU FOR BUYING A
HOTPOINT-ARISTON PRODUCT
In order to receive a more complete assistance, please
register your product on www . hotpoint . eu/ register
Before using the appliance carefully read the Safety
Instruction.
PRODUCT DESCRIPTION
FIRST TIME USE
AIR VENT (FOR THE SUCTION VERSIONS)
Connect the hood and discharge holes on the walls with a diameter
equivalent to the air outlet (connection ange).
Using the tubes and discharge holes on walls with smaller dimensions
will cause a diminution of the suction performance and a drastic
increase in noise.
Any responsibility in the matter is therefore declined.
! Use a duct of the minimum indispensible length.
! Use a duct with as few elbows as possible (maximum elbow angle: 90°).
! Avoid drastic changes in the duct cross-section.
! The company declines any responsibility whenever these regulations
are not respected.
FILTERING OR DUCTING?
! Your cooker hood is ready to be used in suction version.
To use the hood in ltering version the special ACCESSORY KIT must be
installed.
Check if the ACCESSORY KIT is furnished or must be bought separately.
Note: If furnished, in certain cases, the additional activated carbon ltering
system may be installed on the hood. Information about the conversion of
the hood from suction version to ltering version is present in the Manual
“Safety Instructions & Installation.
DUCTING VERSION
In this case the fumes are conveyed outside of the building by means
of a special pipe connected with the connection ring located on top of
the hood.
Attention! The exhausting pipe is not supplied and must be purchased
apart. Diameter of the exhausting pipe must be equal to that of the
connection ring.
Attention! If the hood is supplied with active charcoal lter, then it
must be removed.
FILTER VERSION
The aspirated air will be degreased and deodorised before being fed
back into the room.
In order to use the hood in this version, you have to install a system of
additional ltering based on activated charcoal.
CONTROL PANEL
The hood is tted with a control panel with aspiration speed selection
control and a light switch to control cooking area lights.
a. ON/OFF lighting
b. OFF motors
c. - d. - e. Minimum suction power (c.), medium (d.), maximum (e.).


TECHNICAL DATA
Height (cm) Width (cm) Depht (cm) Ø of exaust tube (cm)
17. 2 49.3 - 69.3 25.7 12.5
* Available only on certain models
Vue de la page 0
1 2

Résumé du contenu

Page 1 - PRODUCT DESCRIPTION

ENQuick guideTHANK YOU FOR BUYING A HOTPOINT-ARISTON PRODUCTIn order to receive a more complete assistance, please register your product on www . hot

Page 2 - TROUBLESHOOTING

CLEANING AND MAINTENANCECLEANING• Do not use steam-cleaning equipment.• Disconnect the appliance from the mains.Important: do not use corrosive or a

Commentaires sur ces manuels

Pas de commentaire