Hotpoint HHP6.5CM Mode d'emploi Page 11

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 16
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 10
GB
11
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
Grease/odour lter warnings
Thebaratthetopleftashestoindicate
thatthegreaselterissaturated.
Thebaratthetoprightashestoindicate
thattheodourlterissaturated.
Ifbothbarsareashing,thenbothlters
are saturated.
Youmustthenclean/replacethegreaselter(A) or odour
lter(B)orboth,accordingly(see“Maintenanceandcare”).
Thelatteronlyappliestothelterversion.
To reset the lter counter:
Hold down T4 for three seconds while the hood is on.
Ifbothlterwarningsareactiveatthesametime,youmust
reset each separately.
Therstsequenceresetsthegreaselter,whilethesecond
sequenceresetstheodourlter.
Conguring the hood
To set the operating mode of the hood, hold down T4 for 6
seconds. After a long beep, the type of installation displays:
Ducted
(squareatbottomleftashing).
Filter
(squareatbottomrightashing).
You can change the type of installation by pressing T4. To
quitcongurationmode,pressT1 once; this switches the
unit off and saves the last displayed setting.
Maintenance and care
Caution! Before cleaning or servicing the unit,
disconnect it from the mains by pulling the power plug
or disconnecting the main circuit breaker.
First cleaning
• Removetheprotectivelm
• Cleanwithadampspongeandalittleneutralsoap
• Rinseoffwithadampcloth
• Drywithasoftcloth;ifthehoodisstainlesssteel,dry
alongthemetal'sgrain
Periodic cleaning
The hood must be cleaned frequently (at least as often as
youservicethegreaselter),insideandout.Useadamp
cloth and a neutral liquid detergent with lukewarm water.
Do not use abrasive or corrosive products.
Warning:Failuretoobservethehoodcleaningandlter
cleaning/replacementinstructionscanresultinres.Follow
the instructions carefully. The manufacturer is not liable for
anydamagetothemotororrescausedbyincorrectcare
or failure to follow the above instructions.
Servicing the grease lter (A)
A
The grease lter retains the
particles of grease produced
during cooking; it must be
cleaned at least once a month
with a non-aggressive
detergent, either by hand or
with a low temperature, short
dishwasher cycle.
To extractthe grease lter,
pull the spring loaded handle.
If washed in a dishwasher, the metal lter may change
colour, but this does not affect its performance.
Servicing the charcoal lter (B)
B
The charcoal filter retains
unpleasant cooking odours.
The filter saturates after a
variable time, depending on
the type of cooking and how
often the grease filter is
cleaned. The cartridge must
be replaced at least once
every twenty months.
ThisltercanNOTbewashed
or regenerated
Disassembly:Rotatethelter90°toremoveitfromthe
suction assembly.
Assembly: Fit the active-carbon lter into the suction
assembly and rotate it 90° to secure it in place.
Replacing the bulbs
Disconnect the unit from the mains and remove the grease
lter.
Caution! Make sure the bulbs are cool before touching
them.
1.Extracttheguard
by prising it out with a small
flat head screwdriver or
something similar.
2. Replace the faulty bulb.
Use only bulbs of the
same type (for details,
see the technical data in
the following manual).
3.Rettheguard(pushitin).
Vue de la page 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire