Hotpoint WHSS 90F L T B K Guide de l'utilisateur

Naviguer en ligne ou télécharger Guide de l'utilisateur pour Hottes de cuisine Hotpoint WHSS 90F L T B K. Hotpoint WHSS 90F L T B K Setup and user guide Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 3
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
EN
Quick guide
THANK YOU FOR BUYING A WHIRLPOOL PRODUCT
In order to receive a more complete assistance, please
register your product on www . whirlpool . eu/ register
Before using the appliance carefully read the Safety
Instruction.
PRODUCT DESCRIPTION
FIRST TIME USE
AIR VENT (FOR THE SUCTION VERSIONS)
Connect the hood and discharge holes on the walls with a diameter
equivalent to the air outlet (connection ange).
Using the tubes and discharge holes on walls with smaller dimensions
will cause a diminution of the suction performance and a drastic
increase in noise.
Any responsibility in the matter is therefore declined.
! Use a duct of the minimum indispensible length.
! Use a duct with as few elbows as possible (maximum elbow angle: 90°).
! Avoid drastic changes in the duct cross-section.
! The company declines any responsibility whenever these regulations
are not respected.
FILTERING OR DUCTING?
! Your cooker hood is ready to be used in suction version.
To use the hood in ltering version the special ACCESSORY KIT must be
installed.
Check if the ACCESSORY KIT is furnished or must be bought separately.
Note: If furnished, in certain cases, the additional activated carbon ltering
system may be installed on the hood. Information about the conversion of
the hood from suction version to ltering version is present in the Manual
“Safety Instructions & Installation.
DUCTING VERSION
In this case the fumes are conveyed outside of the building by means
of a special pipe connected with the connection ring located on top of
the hood.
Attention! The exhausting pipe is not supplied and must be purchased
apart. Diameter of the exhausting pipe must be equal to that of the
connection ring.
Attention! If the hood is supplied with active charcoal lter, then it
must be removed.
FILTER VERSION
The aspirated air will be degreased and deodorised before being fed
back into the room.
In order to use the hood in this version, you have to install a system of
additional ltering based on activated charcoal.
CONTROL PANEL
T1. ON/OFF “Night Light”
T2. Hob lights ON/OFF – Select the colour
temperature
T3. Operation “ZEN Mode”
T4. Motor ON/OFF
T5. "POWER BOOST 1" function
T6. "POWER BOOST 2" function
T7. Automatic Mode“Cook Sense”
T8. Filter saturation indicator
T9. ON/OFF operating mode “Daily Air
Sense”
T10. ON/OFF operating mode“Intensive Air
Sense “
T1. ON/OFF “NIGHT LIGHT”
Press to switch the soft background lighting on or o.
T2.
HOB LIGHTS ON/OFF – SELECT THE COLOUR TEMPERATURE
Press to switch the hob lights on or o.
With the lights on, use your nger to swipe right or left over the
SL1 LED strip to increase or decrease the intensity of the light.
To set the colour temperature of the lighting
Press (and hold) again,
using your nger to swipe right or left over the SL1 LED strip to set
the intensity of the light colder or warmer.
If you do not change the colour for ve seconds, SL1 will ash at the
colour setting you have selected and an audible signal will sound to
indicate that the system has saved this conguration.
Please note: The light will come on at the last intensity you set before
switching the appliance o.
T3. OPERATION “ZEN MODE”
Press to activate or deactivate the "ZEN" extraction mode.
This function makes it possible to activate an extraction speed with the
perfect balance between quietness and extraction eciency.
T4. MOTOR ON/OFF
Press to switch the extraction motor on or o.
With the motor on, use your nger to swipe right or left over the
SL2 LED strip to increase or decrease the extraction speed.
T5. "POWER BOOST 1" FUNCTION
With the extraction motor on, press T5 to activate the "POWER BOOST
1" intensive extraction speed (time-controlled).
Please note: the hood will go back to running at the speed it was
previously using after ve minutes.
T6. "POWER BOOST 2" FUNCTION”
With the extraction motor on, press T6 to activate the "POWER BOOST
2" intensive extraction speed (time-controlled).
Please note: the hood will go back to running at the speed it was
previously using after ve minutes.
T7. AUTOMATIC MODE “COOK SENSE”
The hood will increase the extraction speed to 1 automatically if the
sensor in the hood detects that the ambient conditions require this.
If the ambient conditions do not change – and the hood is already
using extraction speed 1 – the hood will switch o after ve minutes.
Please note: to make sure this function is used correctly, please congure
the parameters for automatic mode rst as described in the relevant
section.
Please note: when using automatic mode, if you change any other
functions that control the speed, the “Cook Sense function will switch o.
Vue de la page 0
1 2 3

Résumé du contenu

Page 1 - PRODUCT DESCRIPTION

ENQuick guideTHANK YOU FOR BUYING A WHIRLPOOL PRODUCTIn order to receive a more complete assistance, please register your product on www . whirlpool .

Page 2 - CLEANING AND MAINTENANCE

T8. FILTER SATURATION INDICATORSAt regular intervals, the hood signals the need to perform lter maintenance.Please note: The indicators will only wor

Page 3 - TROUBLESHOOTING

MAINTENANCE OF THE CHARCOAL FILTER (FOR FILTRATION MODELS ONLY)This lter retains the unpleasant odours produced during cooking.Saturation of the carb

Commentaires sur ces manuels

Pas de commentaire