Hotpoint HUE62G Mode d'emploi télécharger pdf (Page 23)

Care and Cleaning

Cleaning the glass doors

DROP DOWN DOORS

Open the door fully and

carefully slide the first

inner glass towards you,

taking care not to allow

the glass to fall.

If necessary, the glass

can be pushed delicately

from the back side.

Repeat the same

procedure with the next

glass.

Now the external glass

panel can be washed.

WARNING! As soon as the inner and middle glass

panels are removed , the door slams shut.

SIDE OPENING DOORS

Cleaning the door glass is the same as the drop

down doors.

Open the lower door

and lift out the inner

door glass

Remove the two

rubber anti-rattle

bungs

Remove the centre

glass taking care to

support the weight of

the glass when

removing and fitting

The glass panels may now be washed at the sink.

Stubborn stains can be removed by using a fine

steel wool soap pad.

Replace in the reverse order.

Ensure anti-rattle bungs are fitted before fitting inner

door glass.

BE CAREFUL NOT TO DAMAGE THE GLASS

PANELS BY PUSHING THEM TOO HARD.

When fitting the glass make sure it is fitted correctly

ie reflective face is fitted the right way round.

Ensure the glass panel is not subjected to any sharp

mechanical blows. Take particular care not to

damage the inner surface which is coated with a heat

reflective layer. After cleaning, rinse and dry with a

soft cloth. For slight soiling the inner glass panel may

be cleaned, while still warm, without removing it from

the door

Warning: Oven must not be operated with inner door

glass removed.

Anti- rattle bung

The door glass is

equipped with anti-rattle

bungs which prevents

rattling of the glass when

opening and shutting the

oven main door. These

can be removed for

washing.

WARNING : Be careful not to lose the bungs when

cleaning

Door and Control Panel (Glass)

Regularly wipe with a clean, damp cloth and polish

with a clean, dry cloth.

Door and Control Panel Trims (Stainless Steel)

Regularly wipe with a clean, damp cloth and polish

with a clean, dry cloth.

Replacement of the Oven Light

WARNING: Ensure that the appliance is switched

off before replacing the lamp to avoid the

possibility of electric shock.

Unscrew the glass cover, using a suitable cloth to

protect the fingers and remove carefully. Unscrew the

existing light bulb, and remove. Screw the new bulb

into position and replace the glass cover, with metal

washer, until positioned securely.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28

Commentaires sur ces manuels

Pas de commentaire

Hotpoint HUE62G Mode d'emploi Page 23

Commentaires sur ces manuels

Produits connexes et manuels pour Cuisiniers Hotpoint HUE62G