Hotpoint E3FX Manuel d'utilisateur télécharger pdf (Page 8)

Electrical Connection

Connecting the supply cord to the electrical mains:

The appliance must be connected to a double pole mains

switch which must be installed between the appliance and

the mains. The double pole mains switch must have a

minimum of 3mm of space between the contacts, be sized

to the load and comply with current regulations (the switch

must not be able to disconnect the earth conductor).

The supply cord should conform to BS6004 conductor size

4mm

and must be positioned so that no part of it reaches

a temperature of 50°C higher than room temperature.

Before making the connection, make sure that:

• the limiter switch (fuse) and the residual wiring can support

the appliance load (see the rating plate).

• the mains system is properly earthed in compliance with

current regulations and provisions.

• there is easy access to the socket or the double pole

mains switch after the appliance is installed.

• the isolation switch must not be positioned directly above

the appliance.

Electrical Connection

THIS APPLIANCE MUST BE EARTHED.

The installation procedure must be carried out by a qualified

electrician.

The electrical safety of this appliance is guaranteed only if

the appliance is correctly earthed in compliance with the

standards of electrical safety.

The manufacturer can under no circumstances be considered

responsible for any damage that might occur due to incorrect

earthing of this appliance.

Power supply 230V

Power 2300W

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Hotpoint E3FX Manuel d'utilisateur Page 8