Hotpoint LSFF 8M126 UK Mode d'emploi télécharger pdf (Page 12)

Notes:

Optimum performance levels when using the “Express” cycle

can be achieved by respecting the specified number of place

settings.

To reduce consumption even further, only run the dishwasher

when it is full.

Note for Test Laboratories: for information on comparative EN

testing conditions, please send an email to the following address:

[email protected]

Special wash cycles

and Options

Wash options

The OPTIONS may only be set, changed or reset after the

wash cycle has been selected and before the Start/Pause

button has been pressed.

Only the options which are compatible with the type of wash

cycle set may be selected. If an option is not compatible

with the selected wash cycle

(see Table of wash cycles)

, the

corresponding symbol flashes rapidly 3 times.

If an option is selected which is not compatible with another

(previously selected) option, it will flash 3 times and switch off,

while the most recently selected option will remain active.

To deselect an option which has been set by mistake, press the

corresponding button again.

* Only available in selected models.

Multi-functional Tablets Option (Tabs)

This option optimises washing and drying results.

When using multi-functional tablets, press the MULTI-

FUNCTIONAL TABLETS button; the corresponding symbol

will light up. If the button is pressed again, the option will be

deselected.

The “Multi-functional tablets” option results in a longer

wash cycle.

Half Load Option using the upper or lower rack

If there are not many dishes to be washed, a half

load cycle may be used in order to save water, electricity and

detergent. Select the wash cycle and then press the HALF LOAD

button: the indicator corresponding to the chosen rack lights up

and the wash cycle starts only in the upper or lower rack.

Remember to load the upper or lower rack only, and to

reduce the amount of detergent accordingly.

Delayed Start Option

It is possible to delay the start time of the cycle by a

period of time between 1 and 24 hours:

1. Select the desired wash cycle and any other options required;

press the DELAYED START button. The indicator light will go

on. Use the same button to select when the wash cycle will start

(h01, h02 etc.)

2. Confirm the selection using the START/PAUSE button to start

the countdown.

3. Once this time has elapsed, the DELAYED START indicator

light goes off and the wash cycle begins.

To deselect the DELAYED START option, press the DELAYED

START button until the text OFF appears.

The Delayed Start function cannot be set once a wash

cycle has started.

1 2 ... 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Hotpoint LSFF 8M126 UK Mode d'emploi Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Lave-vaisselle Hotpoint LSFF 8M126 UK