Hotpoint RLA80 Manuel d'utilisateur télécharger pdf (Page 15)

CLEANING &

MAINTENANCE

Door Reversal

You will need a cross head screwdriver, a flat blade screwdriver and a 5mm spanner to

carry out this procedure.

Our Service Department can arrange for an Engineer to do the conversion for you but

a charge will be made.

WARNING: Switch off electrical supply and pull out the mains plug.

Remove all door furniture and all loose items/fittings from inside the fridge.

If you have previously set up and used the fridge and since decided to reverse the

doors, you must remove stored food, wrap or cover it and place into insulated

containers to keep cool whilst carrying out this operation.

1. Open the door as wide as possible.

Note : You may require assistance to do this:

2. Support the door and using a screwdriver, remove the screw

securing the top hinge.

3. Lower the top hinge and carefully tilt the door to remove the

hinge from the cabinet. Lift the door off the bottom hinge.

4. Remove the top hinge from the door.

5. Remove the spacing washers from the bottom hinge pin.

Door Reversal

7. Unscrew the fixing

screw to remove the

right hand hinge cover

plate.

Then remove the door

stop washer.

11. Firstly put the door stop

washer in position on

the left hand hinge

bracket and then screw

in the hinge pin.

6. Use a flat blade

screwdriver or a 5mm

spanner, to unscrew

and remove the

bottom hinge pin.

8. Replace the right hand

cover plate with its

original screw.

12. Replace the left hand

cover plate with its

original screw.

9. Take the plastic cap

from the left hand

cover plate and use it

to fill the hole on the

right hand cover plate.

10. Unscrew the fixing screw to remove the left hand hinge cover plate.

13. Replace the spacing washers onto the hinge pin.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire

Hotpoint RLA80 Manuel d'utilisateur Page 15

Commentaires sur ces manuels