Hotpoint TCM570 Manuel d'utilisateur télécharger pdf (Page 2)

Important Information

! You MUST clean the fluff filter after EVERY drying

cycle.

Fluff filter...

! Failure to clean the filter after EVERY drying cycle will affect the drying performance of your machine.

- It will take longer to dry and as a result will use more electricity during drying.

! You MUST empty the water container after EVERY

drying cycle.

Water Container...

Priming the Water Collection System

When your dryer is new, the water container will not collect water until the system is primed... this will take 1 or 2 drying

cycles. Once primed it will collect water during every drying cycle.

STEP 1.

Open the door of your

dryer.

STEP 2.

Pull out the filter (using

the two finger grips).

STEP 3.

Clean any fluff deposits

from the filter mesh.

STEP 4.

Refit the filter - NEVER

run the dryer without the

filter in position.

For your Condenser dryer to operate efficiently, you must follow the regular maintenance schedule shown below:

STEP 1.

Pull the water container

towards you and remove it

fully from the dryer.

STEP 2.

Empty all the water

collected in the water

container.

STEP 3.

Refit the water container,

ensuring that it is pushed

fully back into position.

! Failure to empty the water container will result in:

- The machine will stop heating (so the load may still be wet at the end of the drying cycle).

- The ‘Empty Water’ light will illuminate to tell you that the water container is full.

1 2 3 4 5 6 7 ... 15 16

Pas de commentaire

Hotpoint TCM570 Manuel d'utilisateur Page 2