Hotpoint TDL15 Manuel d'utilisateur télécharger pdf (Page 13)

How to remove and clean the fluff filter

Position of filter

To remove the filter

A very important part of your dryer is the fluff filter at

the front edge of the drum. It’s there to trap the

particles of lint and fluff which are normally blown

away when clothes are dried on the washing-line.

if the filter is allowed to become blocked, the passage

of warm air through the drum will be severely

restricted. This means your clothes will take much

longer than normal to dry and the cost of drying them

will be increased. it may also damage your dryer.

Small items, e.g. babies socks, may fall onto the filter.

These should be removed so that the filter is not

restricted.

Grip the centre rib and pull the filter upwards and

forwards through the door seal (see diagram).

Open the filter, and remove the fluff that has collected

on the inside.

Wash or vacuum clean the filter occasionally.

Don’t be alarmed by the amount of fluff you may find

on the filter. It’s part of the wearing, washing and

drying process.

It is essential that the filter is replaced correctly. It

must be fitted so that the symbols, shown on the filter

above, face towards the front of the dryer. Ensure the

filter is fully located into the tumble dryer duct.

WARNING: NEVER USE SHEET

FABRIC CONDITIONER. IT MAY FALL

INTO THE FILTER AND RESTRICT THE

AIRFLOW THROUGH THE DRYER

WARNING: DO NOT OPERATE THE DRYER

WITHOUT CLEANING THE FILTER AFTER

EACH DRYING CYCLE. FAILURE TO CLEAN

THE FILTER MAY RESULT IN A FIRE HAZARD.

WARNING: DO NOT OPERATE THE DRYER

WITHOUT THE FILTER IN POSITION.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Hotpoint TDL15 Manuel d'utilisateur Page 13