Hotpoint TDL15 Manuel d'utilisateur télécharger pdf (Page 14)

TDL14

TDL15

Heat Selection

The ‘Cool

Tumble’ phase

The Controls - TDL14 and TDL15

Heat Switch (OUT low heat, IN high heat) Timer Knob

Turn the timer clockwise to select the required drying time.

The timer controls the drying time for both heat settings. All you have to do is

turn the Timer Knob clockwise slightly past the required time and then back to

the required time.

Do not rotate the knob beyond 120 (maximum drying time), or past the zero

stop. If you have selected more time than you required, turn the knob anti-

clockwise, to select the correct time required.

This operation also starts the dryer, provided the door is closed and the

machine is plugged in. The “Guide To Drying Times” section will tell you how

much time you’ll need for various loads.

Turn the timer clockwise to select the required drying time.

The timer controls the drying time for both heat settings. All you have to do is

turn the Timer Knob clockwise until it lines up with the required time.

Never wind the timer control anti-clockwise.

This operation also starts the dryer, provided the door is closed and the

machine is plugged in. The “Guide To Drying Times” section will tell you how

much time you’ll need for various loads.

The button is ‘OUT’ for LOW heat and ‘IN’ for HIGH heat.

The choice of FULL HEAT or LOW HEAT depends upon the fabric you wish to

dry (see section, ‘Sorting your Laundry’)

About 10 minutes before the programme is completed, the heating elements

will be switched off, and the programme enters the final ‘Cool Tumble’ phase.

During this phase, the fabric is cooled. You should always allow the dryer to

complete this phase.

By opening the door, the dryer will stop and you can check the dryness of the

load as often as you wish and, if you want to remove (or add) some items

before they are fully dry. (This is particularly useful for a mixed load where

you want to iron some items,but others to be fully dried).

We recommend that the clothes are removed immediately the programme is

finished to minimise creasing.

Drying Guide Drying Times

NEVER SWITCH THE DRYER ‘OFF’ WITH A HOT LOAD IN THE

DRUM. YOU MUST TERMINATE EVERY PROGRAMME WITH

THE COOL TUMBLE PHASE.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Hotpoint TDL15 Manuel d'utilisateur Page 14