Hotpoint TDL15 Manuel d'utilisateur télécharger pdf (Page 7)

Where to put and vent your dryer

Your Tumble Dryer should NOT be located adjacent to a gas hob

cooker, heater, or eye level grill as flames from the burners could

cause damage to your machine. When the dryer is fitted under a

work surface allow space for air to enter the rear grille, 10mm

above the dryer minimum.

If you are using this Dryer adjacent or stacked on top of a washing

machine SEPARATE mains plugs and sockets must be used for

each appliance. DO NOT use 2-way adaptors or extension leads.

Both your Tumble Dryer and front loading washing machine are

similar in design allowing the Tumble Dryer to be permanently

stacked on top saving you valuable floor space. A special stacking

kit complete with instructions is available from your retailer or

nearest Spares Centre.

IMPORTANT: Only use genuine stacking kits. When ordering

you must state the model numbers of both your Washing

Machine and your Tumble Dryer. Unsuitable kits may result in

a potential hazard and will invalidate your warranty rights.

Unless the Dryer, when stacked, is directly in front of a

window, we strongly recommend the use of a Vent Hose Kit. (If

this is not supplied it can be obtained from your retailer or

Spares Centre).

The Dryer dries your washing by drawing in air that is cool, clean

and relatively dry, heating it and then blowing it through the clothes

as they are gently tumbled. The moisture laden air is then blown out

at the back of the dryer through the vent hose which is

recommended for optimum performance.

When operating the dryer, there has to be adequate ventilation to

avoid the back flow of gases into the room from appliances burning

other fuels, including open fires.

A vent hose must always be fitted when the dryer is used in

conjunction with Mobile Venting.

The hose must be fitted securely into the back of the dryer (see

diagram on previous page). If possible, it is always best to connect

the hose to a permanent outlet close to the dryer (see instructions

below).

Ensure that the end of the hose is not directed towards the air

intake grille at the rear of the dryer.

If permanent installation is not possible, the dryer will work just as

well with the hose passed through a partly-opened window.

NOTE: The vent hose should not exceed 2.4 metres in length

and should be kept free of any possible accumulation of fluff,

lint (and water) by frequently shaking it out. Always ensure

that the hose is not squashed.

See diagram on previous page.

Stack it on your

Washing Machine

Ventilation

Mobile Venting

Fitting the Vent

Hose Kit

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

Hotpoint TDL15 Manuel d'utilisateur Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Séchoirs Hotpoint TDL15