Hotpoint TVF760 Manuel d'utilisateur télécharger pdf (Page 13)

Important

Information

Installation Description

Start and

Programmes Laundry

Warnings and

Suggestions

Maintenance

and Care

Service

Troubleshooting

One day your dryer seems not to be working. Before you call your Service Centre (see Service), go through the

following troubleshooting suggestions:

Problem:

The tumble dryer won’t start.

Drying cycle will not begin.

Its taking a long time to dry.

Programme finishes and

clothes are damper than

expected.

The display shows a fault

code F followed by one or two

numbers.

The display briefly shows

every 6 seconds.

Possible causes / Solution:

●

The plug is not plugged into the socket, or not making contact.

●

There has been a power failure.

●

The fuse has blown. Try to plug another appliance into the socket.

●

You are using an extension cord? Try to plug the dryer’s power cord

directly into the socket.

●

The door is not closed securely?

●

The PROGRAMMES knob has not been set properly (see Start and

Programmes).

●

The START/PAUSE button has not been pressed (see Start and

Programmes).

●

You have set a delayed time (see Start and Programmes).

●

The filter has not been cleaned (see Maintenance).

●

The correct programme has not been selected for the load (see Start

and Programmes).

●

The flexible vent tube is obstructed (see Installation).

●

The air intake vent is obstructed (see Installation).

●

The permanent ventilation flap on the storm cover is obstructed (see

Installation).

●

The items were too wet (see Laundry).

●

The dryer was overloaded (see Laundry).

! For safety the dryer has a maximum programme time of 3 hours. If an

automatic programme has not sensed the required final moisture in this time

the dryer will complete the programme and stop. Check the above points

and run the programme again, if the results are still damp, contact the

Service Centre (see Service).

●

If the display shows F10 or F15:

- Turn off and remove the plug. Clean the filter (see Maintenance).

Then replace the plug, turn on and start another programme. If F10

or F15 is still displayed contact the Service Centre (see Service).

●

If any other number is shown: Note down the code and contact the

Service Centre (see Service).

●

The dryer is in ‘Demo’ mode. Press and hold both the On/Off and

Start/Pause buttons for 3 seconds. The display will show for

3 seconds and then the dryer will resume normal operation.

1 2 ... 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Hotpoint TVF760 Manuel d'utilisateur Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Séchoirs Hotpoint TVF760