Hotpoint EX901X Manuel d'utilisateur Page 7

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 12
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 6
7
Before cleaning or performing maintenance on your hob,
disconnect it from the power supply. Check that all
controls are in the OFF position before reconnecting.
NEVER USE: Washing powder, harch abrasive,
scouring pads, aerosol cleaners or oven chemical
clearners of any kind.
Cleaning materials to avoid
Household abrasive powders, eg. Vim.
Oven chemical cleaners, aerosols and oven pads -
Caustic cleaners such as these will etch the surface
and attack the metal frame.
Bath and sink cleaners may mark the surface.
The Ceramic Hob
To reduce the amount of cleaning always ensure that
the hob and cooking utensils are clean and dry before
use. Regular use of cleaner conditioner is recommended
for proper care and protection of the hob surface. Apply
conditioner before using the hob for the first time. It
contains a mild cleaning agent, so that subsequent
cleaning applications may clean off soil and apply a
protective film at the same time. For stubborn stains or
heavy soiling use any of the following materials, and
finish off with conditioner:
1. Cif, non-scratch scouring cream.
2. Liquid Gumption Kitchen Cleanser.
3. Special Powder Cleanser.
Care and Cleaning
Troubleshooting
Before calling service for assistance, check through the
following list, there may be nothing wrong.
Nothing works.
Check to make sure that:
the mains wall switch is switched on.
If a control is on, the corresponding residual heat
indicator light will come on.
Hotplates are slow to boil or will not simmer.
Check to make sure that:
Your pans conform with the recommendations detailed
in this book.
If, despite all of these checks, the hob does not function
properly and problem persists, call Hotpoint Service (see
KEY CONTACTS, back page), informing them of:
- The type of problem.
- The abbreviation used to identify the model (Mod. ...)
as indicated on the warranty.
IMPORTANT:
Never call upon technicians not authorized by the
manufacturer, and refuse to accept spare parts that are
not original.
Powder Cleanser - Mineral deposits that are present in
hard water and some foods may cause discolouration,
that appear in the form of grey or brown stains. The stains
sometimes appear to be in or under the glass surface. If
there are any persistent stains after using any of the
other recommended cleaning materials, powder cleanser
may be applied, following the manufactures instructions.
DO NOT use abrasive cleaners or powder cleanser on
the painted metal framework. Pans with aluminium bases
should be lifted rather than dragged across the hob
surface. This will avoid metal rubbing off the pan onto
the glass. Such marks are easily removed by the powder
cleanser provided they are not subsequently baked on
for long periods at high temperatures.
Cleaner Conditioner - Regular use of the conditioner
will make the surface easier to clean thus ebsuring that
years of heavy abrasive cleaning do not progressively
dull the surface. If the hob is scratched through accident
or misuse. soil that collects will appear as fine brown
lines; these are not fully removable but can be made
less obvious by the daily use of cleaner conditioner.
Cooking performance is in no way affected by scratched
on the surface.
Control Knobs
Wipe over the knobs with a soft cloth wrung out in warm
soapy water or mild non-abrasive. Then, after wiping with
a cloth wrung out in clear water, dry with a soft clean
cloth.
Painted Metal Surround Trim
Wipe over with a cloth wrung out in warm soapy water
only. DO NOT USE ABRASIVES.
Stainless Steel
Wipe with a cloth wrung out in warm soapy water followed
by a wipe with a cloth wrung out in clean water and then
dry with a soft clean cloth.
Vue de la page 6
1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire