Hotpoint EX901X Manuel d'utilisateur Page 8

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 12
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 7
8
Installation
fig.3
fig.2
wall
1.5 mm1.5
mm
A
B
C
XmmX
mm
XmmX
mm
The following instructions are provided for qualified
installers so that they may accomplish installation,
adjustment and technical maintenance operations
correctly and in compliance with current regulations and
standards.
Important: the hob should be disconnected from the
mains electricity supply before any adjustment,
maintenance, etc. is carried out.
Maximum caution should be used whenever it is
necessary to keep the appliance connected to the
electricity supply.
Installation
These instructions are given for a class 1 appliance.
Suitable precautions must be taken to ensure that the
installation is in compliance with current accident-
prevention regulations regarding electrical connection.
When installing above a built-under oven, suitable air
vents should be provided for as shown in fig.1 (inlet at
least 200 cm² from the bottom, outlet at least 180 cm²
from the top part) to allow adequate ventilation inside
the housing unit.
The electricity supply cable must not touch hot parts of
the oven housing, in order to avoid overheating.
When installing above a built-under oven without forced
cooling ventilation, a wooden panel “A” (fig.1) should be
installed beneath the hob as insulation, positioning it at
a minimum distance of 15 mm from the hob housing.
For trouble-free operation of the appliance set into
kitchen units, the minimum distances indicated in fig.2
should be complied with.
The hob has a protection rating Y against overheating,
in accordance with standard EN60335-2-6. The surfaces
adjoining the unit and the wall to the rear should be in
suitable material to withstand a temperature of 65°C.
To fix the hob to the unit, proceed as follows (fig.3);
tighten 2 screws “A” (provided) into the unit, leaving
the screw heads projecting 1.5 mm from the wood;
hook the hob onto the 2 screws “A” and push
backwards;
fig.1
15mm
180cm²
A
Vue de la page 7
1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire