Hotpoint AQC9 6F7 TM1 (EU) Mode d'emploi télécharger pdf (Page 20)

Important Information

For your Condenser dryer to operate efficiently,

you must follow the regular maintenance schedule

shown below:

Fluff Filter – You MUST Clean the fluff filter after

every drying cycle.

Step 1

Open the door of your dryer.

Step 2

Pull out the filter (using the two

finger grips).

Step 3

Open the filter by releasing the

clip.

Step 4

Clean any fluff deposits from the

inside surface of the filter mesh.

Step 5

Refit the filter – Never run the

dryer without a filter.

Failure to clean the filter after every drying cycle will

affect the drying performance of your machine – It

will take longer to dry and as a result will use more

electricity during drying.

Water Container – You must empty the water

container after every drying cycle.

Step 1

Pull the water container

towards you and remove it fully

from the dryer.

Step 2

Empty the Water from the

Container.

Step 3

Refit the Water Container

ensuring that it is pushed fully

back into position.

Failure to empty the Water Container will result in:

- The machine will stop heating (so the load may be

wet at the end of the cycle).

- The ”Empty Water” light will flash to tell you that

the Container is full.

! The water bottle/clean filter

light comes on when you select

a programme to remind you to

make sure that the water bottle

is empty and that the filter is

clean before starting a new

cycle’

Priming the Water Collection System

When your dryer is new, the Water Container will not

collect Water until the system is primed, this will take

1 or 2 drying cycles. Once primed it will collect Water

during every cycle.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 55 56

Commentaires sur ces manuels

Pas de commentaire

Hotpoint AQC9 6F7 TM1 (EU) Mode d'emploi Page 20

Commentaires sur ces manuels

Produits connexes et manuels pour Sèche-linge électrique Hotpoint AQC9 6F7 TM1 (EU)