Hotpoint DSKS333ECWW Manuel d'installation Page 2

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 4
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 1
FOR THREE-WIRE SUPPLY
(208V & 240V MODELS)
Remove terminal block cover.
&RQQHFWWZR+27OLQHVWRRXWHUVFUHZV/DQG/RI
terminal block.
Connect Neutral line to center
VFUHZ1RIWHUPLQDOEORFN
Properly strain relief the cordset or cable to the cable entry
hole with UL recognized strain relief.
Replace terminal block cover.
FOR FOUR-WIRE SUPPLY
(208V & 240V MODELS)
Remove terminal block cover.
5HPRYHJURXQGVWUDSDQGGLVFDUG5HVFUHZJUHHQ
grounding screw in place.
&RQQHFWWZR+27OLQHVWRRXWHUVFUHZV/DQG/RI
terminal block.
&RQQHFW1HXWUDOOLQHWRFHQWHUVFUHZ1RIWHUPLQDOEORFN
Attach ground wire of power
supply to green grounding screw
beside terminal block.
Properly strain relief the cordset or cable to the cable
entry hole with UL recognized strain relief.
Replace terminal block cover.
Typical 30 amp receptacle for use where
local codes permit use of flexible type
power supply cord (pigtail).
3 WIRE RECEPTACLE
(10-30R)
7KH RSHUDWLQJ YROWDJH 9ROWV $PSHUDJH $PSV DQG
)UHTXHQF\ +] RI WKLV GU\HU DUH LQGLFDWHG RQ WKH 5DWLQJ
Plate located to the right of the loading port.
Connect this dryer to a circuit corresponding to that
indicated on Rating Plate and protected by fuses or a
circuit breaker in accordance with local codes.
Use a power supply cord kit marked for use with clothes
GU\HU)RU9DQG9PRGHOVXVHDSRZHUVXSSO\FRUG
kit marked for use with clothes dryers.
)RUDOWHUQDWH9RU9SRZHUVXSSO\KRRNXSSURFHHG
DVIROORZV
Connect supply wire leads to terminal block as shown on
sketch below, depending on type of installation.
Make sure screws on terminal block are tight.
This appliance must be grounded. In the event of malfunction
or breakdown, grounding will reduce the risk of electric shock
by providing a path of least resistance for electrical current.
WARNING: Improper connection of the
equipment grounding conductor can result in a risk of electric
VKRFN&KHFNZLWKDTXDOL¿HGHOHFWULFLDQRUVHUYLFHPDQLI\RX
are in doubt as to whether the appliance is properly grounded.
'RQRWPRGLI\WKHSOXJSURYLGHGZLWKWKHDSSOLDQFHLILWZLOOQRW¿W
WKHRXWOHWKDYHDSURSHURXWOHWLQVWDOOHGE\DTXDOL¿HGHOHFWULFLDQ
WARNING: Appliance grounded to neutral
conductor through a link. If used in a mobile home, a new
construction, a recreational vehicle or if local codes do not
SHUPLWJURXQGLQJWKURXJKQHXWUDODFRQGXFWRUFRUGRUFDEOH
assembly for use with clothes dryers must be used with the
IROORZLQJ VSHFL¿FDWLRQV 7\SH 6W &DEOH  0LQ 9ROW
 $PS ZLWK FORVHGORRS WHUPLQDOV DQG VHFXUHG ZLWK D 8/
recognized strain relief. See manufacturer’s instructions.
2
ELECTRICAL CONNECTION DETAILS
OBSERVE ALL GOVERNING CODES AND ORDINANCES
DO NOT USE EXTENSION CORD WITH THIS APPLIANCE
GROUNDING INSTRUCTIONS
POWER SUPPLY
&25'$:*
MINIMUM COPPER
CONDUCTORS
$039
WITH TYPE UL
5(&2*1,=('
MINIMUM RATED
&
2592/7
23(5$7,21
OR 120/240 VOLT
6833/<86(21/<
$03)86(6
POWER SUPPLY CORD
$:*0,1,080
&233(5&21'8&7256
$039:,7+&/26('
LOOP TERMINALS TYPE UL
5(&2*1,=('0,1,080
5$7('&
FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE
PROPERLY GROUNDED.
FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE
PROPERLY GROUNDED.
5(029(*5281'675$3
$1'',6&$5'25
92/723(5$7,2125
92/76833/<86(
21/<$03)86(6
Typical 30 amp receptacle for use
where local codes permit use of
flexible type power supply cord
(pigtail).
Typical 30 amp cord assembly for
use where local codes do not
permit grounding through neutral.
4-WIRE RECEPTACLE (14-30R)
4-CONDUCTOR CORD
ASSEMBLY ( Type ST Cable)
X
W
G
Y
*UHHQRU<HOORZ
*URXQG:LUH
Hot Wire
*UHHQ
*URXQGLQJ
Screw
*URXQG
Strap
White Neutral Wire
Hot Wire
*UHHQ*URXQGLQJ6FUHZ
Hot
Wire
White Neutral Wire
Hot
Wire
Vue de la page 1
1 2 3 4

Commentaires sur ces manuels

Pas de commentaire