Hotpoint DSKS333ECWW Manuel d'installation télécharger pdf (Page 3)

DRYER TOP VIEW

IF YOUR DRYER COMES WITH REAR EXHAUST,

TO CHANGE TO SIDE OR BOTTOM EXHAUST:

• Remove access panel at back of dryer to gain access

to internal ducts.

• Disconnect duct exhaust from blower housing

UHPRYHWDSHVHFXULQJGXFW

FOR SIDE EXHAUST:

5HPRYHGHVLUHGNQRFNRXWSODWHHLWKHUULJKWRUOHIWVLGH

&XWDPPòµOHQJWKRIPPµGLDULJLG

GXFWDVVKRZQUHPRYHEXUUVIURPFXWHGJH

• Attach this extension duct to blower housing duct.

$WWDFKDHOERZIDFLQJGHVLUHGRSHQLQJ

$WWDFKDVHFWLRQRIPPµGLDULJLGGXFW

to elbow to protrude through side of cabinet.

• Seal all joints with duct tape.

• Reinstall rear access panel.

FOR BOTTOM EXHAUST:

• Remove cover plate at bottom of dryer.

,QVWDOODHOERZ

• Seal all joints with duct tape.

• Reinstall rear access panel.

3ODFHFRYHUSODWHUHPRYHGIURPERWWRP

RIGU\HURYHUUHDUH[KDXVWRSHQLQJ

IF YOUR DRYER COMES WITH TOP EXHAUST,

TO CHANGE TO SIDE OR REAR EXHAUST:

• Remove rear access panel.

'LVFRQQHFW UHWDLQLQJSODWH DQG HOERZE\ UHPRYLQJ

mounting screw from the chassis and remove tape

securing elbow to blower housing.

• Remove cover plate from rear access panel and place

over top exhaust opening.

FOR SIDE EXHAUST:

5HPRYHGHVLUHGNQRFNRXWSODWHHLWKHUULJKWRUOHIWVLGH

7DNH WKH GXFW SUHYLRXVO\ UHPRYHG DQG FXW D  PP

 òµ OHQJWK RI  PP µ GLD ULJLG GXFW DV VKRZQ

UHPRYHEXUUVIURPFXWHGJH

• Attach this extension duct to blower housing duct.

$WWDFKWKHHOERZIDFLQJGHVLUHGRSHQLQJ

$WWDFKDVHFWLRQRIPPµGLDULJLGGXFWWRHOERZWR

protrude through side of cabinet.

• Seal all joints with duct tape.

• Reinstall rear access panel.

FOR REAR EXHAUST:

&XWDPPò´OHQJWKRIPPµGLDULJLG

GXFWDVVKRZQUHPRYHEXUUVIURPFXWHGJH

• Attach this extension duct to blower housing.

• Seal all joints with duct tape. Reinstall near access panel.



EXHAUST INFORMATION

WARNING - IN CANADA AND IN THE

UNITED STATES, THE REQUIRED EXHAUST DUCT

DIAMETER IS 4 in (102mm). DO NOT USE DUCT LONGER

THAN SPECIFIED IN THE EXHAUST LENGTH TABLE.

8VLQJH[KDXVWORQJHUWKDQVSHFL¿HGOHQJWKZLOO

• Increase the drying times and the energy cost.

• Reduce the dryer life.

$FFXPXODWHOLQWFUHDWLQJDSRWHQWLDO¿UHKD]DUG

WARNING - BEFORE PERFORMING THIS

EXHAUST INSTALLATION, BE SURE TO DISCONNECT

THE DRYER FROM ITS ELECTRICAL SUPPLY.

The correct exhaust installation is YOUR RESPONSIBILITY. Problems

due to incorrect installation are not covered by the warranty.

Remove and discard existing plastic or metal foil transition duct and

UHSODFHZLWK8/OLVWHGWUDQVLWLRQGXFW

The MAXIMUM ALLOWABLE duct length and number of bends of the

exhaust system depends upon the type of duct, number of turns, the

W\SHRIH[KDXVWKRRGZDOOFDSDQGDOOFRQGLWLRQVQRWHGEHORZ7KH

maximum duct length for rigid metal duct is shown in the table on

the next page.

EXHAUST SYSTEM CHECK LIST

HOOD OR WALL CAP

• Terminate in a manner to prevent back drafts or entry of birds or

other wildlife.

• Termination should present minimal resistance to the exhaust

DLU ÀRZ DQG VKRXOG UHTXLUH OLWWOH RU QR PDLQWHQDQFH WR SUHYHQW

clogging.

• Never install a screen in or over the exhaust duct. This could cause

lint build up.

•

Wall caps must be installed at least 12 in. above ground level or any

other obstruction with the opening pointed down.

SEPARATION OF TURNS

For best performance, separate all turns by at least 4 ft. of straight

duct, including distance between last turn and exhaust hood.

TURNS OTHER THAN 90º

 2QHWXUQRIRUOHVVPD\EHLJQRUHG

 7ZRWXUQVVKRXOGEHWUHDWHGDVRQHWXUQ

 (DFKWXUQRYHUVKRXOGEHWUHDWHGDVRQHWXUQ

SEALING OF JOINTS

• All joints should be tight to avoid leaks. The male end of each

section of duct must point away from the dryer.

• The duct shall not be assembled with screws or other fastening

means that extend into the duct and catch lint.

 'XFWMRLQWVFDQEHPDGHDLUDQGPRLVWXUHWLJKWE\ZUDSSLQJWKH

overlapped joints with duct tape.

• Horizontal runs should slope down toward the outdoors

1/4 inch

per foot.

INSULATION

Ductwork that runs through an unheated area or is near air conditioning

VKRXOGEHLQVXODWHGWRUHGXFHFRQGHQVDWLRQDQGOLQWEXLOGXS

EXHAUST CONNECTION

WARNING - TO REDUCE THE RISK OF

FIRE OR PERSONAL INJURY:

•

This clothes dryer must be exhausted to the outdoors.

• Use only 4” rigid metal ducting for the home exhaust duct.

8VHRQO\µULJLG PHWDO RU 8/OLVWHG ÀH[LEOH PHWDOVHPLULJLGRU

IRLOW\SH GXFW WR FRQQHFW WKHGU\HU WR WKH KRPH H[KDXVW GXFW

It must be installed in accordance with the instructions found in

“Connecting the Dryer to House Vent” on page 4 of this manual.

• Do not terminate exhaust in a chimney, a wall, a ceiling, gas

YHQWFUDZOVSDFHDWWLFXQGHUDQHQFORVHGÀRRURULQDQ\RWKHU

concealed space of a building. The accumulated lint could create

DSRWHQWLDO¿UHKD]DUG

• Never terminate the exhaust into a common duct with a kitchen

exhaust system. A combination of grease and lint creates a

SRWHQWLDO¿UHKD]DUG

'RQRWXVHGXFWORQJHUWKDQVSHFL¿HGLQWKHH[KDXVWOHQJWKWDEOH

/RQJHUGXFWVFDQDFFXPXODWHOLQWFUHDWLQJDSRWHQWLDO¿UHKD]DUG

• Never install a screen in or over the exhaust duct. This will cause

OLQWWRDFFXPXODWHFUHDWLQJDSRWHQWLDO¿UHKD]DUG

• Do not assemble ductwork with any fasteners that extend into the

duct. These fasteners can accumulate lint, creating a potential

¿UHKD]DUG

• Do not obstruct incoming or exhausted air.

• Provide an access for inspection and cleaning of the exhaust

system, especially at turns and joints. Exhaust system shall be

inspected and cleaned at least once a year.

ALTERNATE EXHAUST INSTRUCTIONS

Left knockout

Bottom

knockout

Right knockout

Blower

Front of dryer

152

203 mm

(8”)

89 mm

(3½”)

6”

For Rear Exhaust

For Side Exhaust

Rigid

Metallic

Ducting

Cut Here

EXTENSION DUCT

It is importat to replace the ground clip after

cuttin

the exhaust duct,

(

on rear exhaust model

)

295 mm

115 mm (4½”)

(11½”)

1 2 3 4

Commentaires sur ces manuels

Pas de commentaire

Hotpoint DSKS333ECWW Manuel d'installation Page 3

Commentaires sur ces manuels

Produits connexes et manuels pour Sèche-linge électrique Hotpoint DSKS333ECWW