Hotpoint EV302X Manuel d'utilisateur télécharger pdf (Page 9)

Electrical Connection

Connecting the supply cord to the electrical mains:

The hob must be connected to a double pole mains switch

which must be installed between the appliance and the

mains. The double pole mains switch must have a minimum

of 3mm of space between the contacts, be sized to the

load and comply with current regulations (the switch must

not be able to disconnect the earth conductor).

The supply cord should conform to BS6004 conductor size

4mm

and must be positioned so that no part of it reaches

a temperature of 50°C higher than room temperature.

Before making the connection, make sure that:

• the limiter switch (fuse) and the residual wiring can support

the appliance load (see the rating plate, below).

• the mains system is properly earthed in compliance with

current regulations and provisions.

• there is easy access to the socket or the double pole

mains switch after the appliance is installed.

• the isolation switch must not be positioned directly above

the appliance.

IMPORTANT:

If the hob is installed above a built-in oven, the electrical

connection for the hob must be independent of that for the

oven, both for safety reasons and to facilitate the removal of

the oven for maintenance, repair etc.

Electrical Connection

THIS APPLIANCE MUST BE EARTHED.

The installation procedure must be carried out by a qualified

electrician.

The electrical safety of this appliance is guaranteed only if

the appliance is correctly earthed in compliance with the

standards of electrical safety.

The manufacturer can under no circumstances be considered

responsible for any damage that might occur due to incorrect

earthing of the hob.

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Hotpoint EV302X Manuel d'utilisateur Page 9