Hotpoint V4D 01 P (UK) Mode d'emploi

Naviguer en ligne ou télécharger Mode d'emploi pour Sèche-cheveux Hotpoint V4D 01 P (UK). Hotpoint V4D 01 P (UK) Instruction for Use Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 4
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté4.8 / 5. Basé sur32 avis des utilisateurs
Vue de la page 0
Instruction booklet
TUMBLE DRYER
FLUFF FILTER
You must clean the fl uff lter after EVERY drying cycle.
Step 1 - Open the door of your dryer, remove the fi ler.
Step 2 - Clean any fl uff deposits from the fi lter mesh, and refi t the fi lter.
Step 3 - Make sure the fi lter is pushed fully home - NEVER run the dryer
without the fi lter in position.
Failure to clean the fi lter after EVERY drying cycle will affect the drying
performance of your machine.
V4D 01 P
To remove the fi lter
!
Installation
WHERE TO PUT YOUR DRYER
The dyer should be placed where air can freely
circulate around it preferably near a window
that can be opened to reduce the possibility of
condensation occurring while the dryer is in use.
If the dryer is enclosed or fi tted under a work
surface a gap of at least 50 mm (2”) must be
allowed above the top for the full width of the dryer
and at least 25 mm (1”) either side. This allows
air to enter into the rear air inlet. The dryer must
never be run in a cupboard with a closed door.
The dryer must never be installed behind a
lockable door, a sliding door or a door with a hinge
on the opposite side to that of the dryer door.
This symbol reminds you to read this booklet.
VENTILATION
When the dryer is in use there has to be adequate
ventilation to avoid the back fl ow of gases into
the room from appliances burning other fuels,
including open fi res.
The vent tube should not exceed 2.4 metres in length.
The tube should be kept clear of the air intake vent
and kinks or ‘U’ bends must be avoided as these
will obstruct the tube and trap condensation.
ELECTRICAL CONNECTIONS
The socket must be grounded. The power supply cord should be checked periodically and, if required,
replaced by a cord specially prepared for this dryer.
Laundry
MAX LOAD SIZE
Do not load more than maximum capacity.
These numbers refer to dry weight:
Natural fi bres: 4kg max
Synthetic fi bre: 2kg max
WASH CARE LABELS
Look at the labels on your garments, especially when tumble drying
for the fi rst time. The following symbols are the most common:
May be tumble dried
Do NOT tumble dry
Tumble dry at high heat setting
Tumble dry at low heat setting
ITEMS NOT SUITABLE FOR TUMBLE DRYING
1. Articles that contain rubber or rubber-like materials or plastic
lm, any fl ammable articles or objects that contain fl ammable
substances.
2. Glass fi bres.
3. Items which have been dry cleaned.
4. Large bulky items (quilts, sleeping bags, etc). These expand
when drying and prevent airfl ow through the dryer.
Vue de la page 0
1 2 3 4

Résumé du contenu

Page 1 - Installation

Instruction bookletTUMBLE DRYERFLUFF FILTERYou must clean the fl uff fi lter after EVERY drying cycle.Step 1 - Open the door of your dryer, remove the fi

Page 2 - Warnings

Warnings! This appliance has been designed and built according to international safety standards. These warnings are given for safety reasons and must

Page 3 - Troubleshooting

• Do not tumble dry items containing foam rubber (also known as latex foam), or similarly textured rubber like materials. Foam rubber materials can, w

Page 4 - 11/2016 Xerox Fabriano

DISPOSAL OF OLD ELECTRICAL APPLIANCESThe European Directive 2012/19/EC on Waste Electrical and Electronic Equipment (WEEE) requires that old household

Commentaires sur ces manuels

Pas de commentaire