Hotpoint NRA 640 C AUS S Mode d'emploi télécharger pdf (Page 9)

• Make sure that the base of the cookware is always

clean and dry, in order to fully utilise and extend the

life of both the cooking zones and the cookware.

• Avoid using the same cookware which has been

used on gas burners: the heat concentration on gas

burners may distort the base of the pan, causing it

not to adhere correctly.

Safety devices

Pan sensor

Each cooking zone is equipped with a pan sensor

device. The hotplate only emits heat when a pan with

suitable measurements for the cooking zone is placed

on it. If the indicator light is flashing, it may indicate:

• An incompatible pan

• A pan whose diameter is too small

• The pan has been removed from the hotplate.

Residual heat indicators

Each cooking zone is equipped with a residual heat

indicator. This indicator signals which cooking zones

are still at a high temperature. If the power display

shows

, the cooking zone is still hot. It is possible,

for example, to keep a dish warm or melt butter or

chocolate. As the cooking zone cools, the power

display will show . The display switches off when the

cooking zone has cooled sufficiently.

Overheating protection

If the electronic elements overheat, the hob switches

off automatically and

appears on the display,

followed by a flashing number. When the temperature

has reached a suitable level, this message disappears

and the hob may be used again.

Safety switch

The appliance has a safety switch which automatically

switches the cooking zones off after they have been

in operation for a certain amount of time at a particular

power level. When the safety switch has been

triggered, the display shows “0”.

For example: the right rear hotplate is set to 5 and will

switch off after 5 hours of continuous operation, while

the front left hotplate is set to 2 and will switch off after

8 hours.

Power level

Maximum operating time in hours

Buzzer

This can also indicate several irregularities:

• An object (a pan, cutlery, etc.) has been placed on

the control panel for more than 10 seconds.

• Something has been spilt on the control panel.

• A button has been pressed for too long. All of the

above situations may cause the buzzer to sound.

Remove the cause of the malfunction to stop the

buzzer. If the cause of the problem is not removed,

the buzzer will keep sounding and the hob will

switch off.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Hotpoint NRA 640 C AUS S Mode d'emploi Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Plaques chauffantes Hotpoint NRA 640 C AUS S