2626
en
TROUBLESHOOTING
Problem Possible causes/Solutions
The soleplate stays cold and does
not warm up.
The plug might not be properly inserted into the power outlet.
Try changing the power outlet.
The temperature indicator light
The product is heating up. When the selected programme
reaches the set temperature, the indicator light remains
steady lit.
If the iron is not used for 8 minutes in the vertical position and
30 seconds in the horizontal position, the automatic switch-
off function intervenes. To switch the iron on again, press the
programme selector button.
No steam or a small
amount of steam
comes out.
There is not enough water in the water reservoir. Fill the water
reservoir.
horizontal position and wait until the temperature indicator
light remains steady lit before starting to iron.
The soleplate temperature may be too low because the shot-
of-steam button has been pressed too many times. Slightly
increase the interval between successive steam shots.
A programme was selected for which the product did not
deem it necessary to emit steam.
In the AUTO operating mode, the iron emits steam continu-
ously only when it moves. When the iron stops moving, steam
sensor that modulates the steam emission in relation to the
iron’s movement.
In the AUTO operating mode, press the steam button to acti-
vate and deactivate continuous steam emission.
-
ceed with the descaling cycle.
The steam shot is emitted in a
reduced quantity or is not emitted
at all.
The AUTO operating mode was selected that does not include
the shot-of-steam function.
Wait at least 15 seconds to activate the shot of steam again.
To activate the shot of steam in the PRO operating mode, rap-
idly press the steam button twice.
An operating mode was selected that does not include the
shot-of-steam function.
-
ceed with the descaling cycle.
Commentaires sur ces manuels