1919
en
Filling the water reservoir (A)
the iron is switched off and disconnected from the
power outlet.
1. Place the product in the vertical position, open
using the water measuring cup supplied with
the iron. Do not exceed the maximum level in-
dicated.
2.
USING THE IRON (B)
1. Insert the iron’s plug into a grounded power out-
to signal that it is powered. The temperature in-
light will light up to signal that the iron is heating
up. The “all fabrics” indicator light and the PRO
mode indicator light refer, respectively, to the de-
fault programme and mode in which the product
activates.
2. When the temperature reaches the level of the
-
3. To select the desired programme, consult the
“Selecting the programmes” paragraph.
SELECTING THE PROGRAMMES
(C)
To select a different programme to the default “all fab-
Whenever the button is pressed, the programme indi-
cator light switches from the “all fabrics” programme
Make sure to check the garment label to determine
the type of fabric then select the most appropriate pro-
gramme. If in doubt, iron a hidden part of the garment
in order to determine the most appropriate tempera-
ture and avoid damaging the fabric. In case of very
delicate fabrics such as silk, wool and synthetic mate-
rials, iron the garment inside out to avoid leaving any
temperature, for example synthetic fabrics.
PROGRAMME FABRIC
TYPE
GARMENT
LABEL
1
All
fabrics
2 Synthetics
3
Delicates
Silk
4 Wool
5 Cotton
6 Linen
THE fabrics marked with this symbol on the
label cannot be ironed.
SELECTING THE OPERATING
MODE (D)
The PRO mode is the product’s default operating
-
for a few seconds. Simultaneously pressing the pro-
allows for switching between modes.
AUTO operating mode (E)
In the AUTO operating mode, the AUTO mode indica-
-
vates the continuous steam emission and the AUTO
operating mode indicator light will become steady lit.
continuous steam emission and the AUTO operating
In the AUTO operating mode, the iron emits steam
continuously only when it moves. When the iron
stops moving, steam is no longer emitted thanks to
the presence of the electronic sensor that modulates
the steam emission in relation to the iron’s movement.
-
ed programme. Check that there is enough water in
the reservoir. To activate and deactivate continuous
In this mode it is not possible to iron with the shot-of-
steam function.
The product is able to assess whether steam is nec-
Commentaires sur ces manuels