Hotpoint SI E40 BA1 UK Mode d'emploi télécharger pdf (Page 9)

Before lling the iron with water, make sure that

the iron is switched-off and disconnected from the

electrical socket.

1. Set the steam regulator (3) to Off.

2. Tilt the iron in such a position to make water

entrance easier.

3. Openthelidofthellerhole(13)andllthewater

reservoir using the water measurer supplied with

theiron.Neverllthewaterreservoirabovethe

maximum water level (10).

4. Closethelidofthellinghole.

Never add any perfume, vinegar, starch,

scale-removing agents, ironing products or

other chemicals in the water reservoir - unless

recommended by Hotpoint. Never use

contaminated water.

USING THE IRON

In order to make reading this instructions manual

easier and identify the model of your Quick Perfect

iron, refer to the graphics on page II.

Your iron is supplied with Power Off System

safety device which automatically switches

the iron off when it is left unattended or tips over

and ensures maximum safety.

Selecting the temperature

and adjusting the steam (B

)

LCD

1. Connect the plug of the appliance into a

grounded socket (220/240V).

2. TheLCD(14)lightsupinredandstartsashing

to indicate that the iron is reaching the set

temperature.

3. Use the temperature buttons +/- (4a) to select

the desired temperature. Every time you press

one of the two buttons, the display lights up and

startsashing to indicatethatthesteamironis

reaching the selected temperature.

4. When the iron reaches the set temperature, the

LCD lights up in green and the set temperature

isshowninxedmodetoindicatethattheiron

is ready for use.

5. Make sure to check the garment label in order

to identify the fabric type. In case of doubts, it

is recommended not to the use spray function

and iron a hidden corner in order to determine

the most appropriate temperature and avoid

damaging the fabric. In case of very delicate

fabrics, such as silk, wool, and synthetic

materials, iron the garment inside out to prevent

shiny marks. Start ironing the garments that

require a lower temperature, such as synthetic

fabrics.

Fabrics with this symbol on the label must

not be ironed.

GARMENT

LABEL

FABRIC TYPE

TEMPERATURE

INDICATION

STEAM

INDICATION

synthetic

silk

mixed cotton

wool

mixed wool

cotton

linen

jeans

6. Select the steam level with the steam regulator

(3) or move it to Off to iron without steam. When

steam ironing, make sure that the water level in

the reservoir is at least ¼.

Selecting the temperature

and adjusting the steam (B

)

1. Connect the plug of the appliance into a

grounded socket (220/240V).

2. Use the temperature control (4b) to select the

desired temperature. If you go from a lower

temperature to a higher temperature, the

temperature indicator light (4c) light up until the

selected temperature is reached.

3. When the iron reaches the set temperature, an

acoustic signal is emitted and the temperature

indicator light goes off.

4. We recommend to check the garment label

in order to identify the fabric type. In case of

doubts, it is recommended not to use the spray

function and iron a hidden corner in order to

determine the most appropriate temperature

and avoid damaging the fabric. In case of very

delicate fabrics, such as silk, wool, and synthetic

materials, iron the garment inside out to prevent

shiny marks. Start ironing the garments that

require a lower temperature, such as synthetic

fabrics.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Hotpoint SI E40 BA1 UK Mode d'emploi Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Fers à repasser Hotpoint SI E40 BA1 UK