Hotpoint DQ891 Manuel d'utilisateur télécharger pdf (Page 23)

Care and Cleaning

CLEANING THE DOORS

Take particular care not to damage the inner

surface of the door inner glass that is coated with

a heat reflective layer. Do not use scouring pads,

or abrasive powder, which will scratch the glass.

Ensure that the glass panel is not subjected to

any sharp mechanical blows.

Stubborn stains can be removed by using a fine

steel wool soap pad. For slight soiling the inner

glass panel may be cleaned, while still warm,

without removing it from the door. After cleaning,

rinse and dry with a soft cloth.

DROP DOWN DOORS

Remove the door inner glass as follows.

1. Open the door fully and remove the extrusion end

caps (This should be done by hand but if it proves

too difficult, simply lift the inner glass to ease the

end caps out of position).

NOTE: If you need to use a tool - be carefulNOTE: If you need to use a tool - be careful

NOTE: If you need to use a tool - be careful

not to damage the extrusion or end cap.not to damage the extrusion or end cap.

not to damage the extrusion or end cap.

2. Carefully slide the inner glass towards you and

withdraw it from its locating slots. Ensure that the

door is not allowed to slam shut, due to the

reduction in door weight. Clean the glass as

described above.

3. The inside of the outer door glass can now be

cleaned while still fitted to the cooker.

NEVER OPERATE THE COOKER WITHOUT THE

INNER DOOR GLASS IN POSITION.

Refit the door inner glass as follows.

1. Open the door fully.

2. Locate the inner door glass into its slots. The inner

door glass has a special reflective coating on one

side, in order to minimise surface temperatures

and energy consumption during use, it is important

it is fitted correctly.

3. Carefully slide the glass into its slots as far as it

will go and replace the top filler cap.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 31 32

Pas de commentaire

Hotpoint DQ891 Manuel d'utilisateur Page 23