Hotpoint S220E Manuel d'utilisateur télécharger pdf (Page 23)

Electrical Requirements

For your own safety, we recommend that your cooker is installed by a competent

person such as one who is registered with NICEIC (National Inspection Council for

Electrical Installation Contracting). The cooker should be installed in accordance with

the latest edition of the IEE Regulations.

Warning: This appliance must be earthed.

Electrical Connections

The installer must check that the voltage shown at the rating plate corresponds with

the house electricity supply.

The cooker must be supplied via a suitable double pole isolating switch, having a

contact separation of at least 3mm in all poles placed in a readily accessible position

adjacent to the cooker.

If the cooker is to be wired into a connector unit, this may be positioned behind the

cooker providing the following requirements are met:

i) The connector unit must not project from the wall more than 25mm.

ii) The top of the connector must not be more than 130mm above floor level.

Remove the terminal cover at the rear base of the cooker. Pass the cable through the

cable clamp and connect to the appropriate terminals provided.

Allow sufficient cable for any future servicing.

Tighten the screws on the cable clamp and replace the cover.

Make main connections in the connector unit or cooker control unit.

This appliance conforms to B.S. EN 55014 regarding suppression of Radio and

Television reception interference.

A double Pole control switch having a minimum rating of 32 amps should be used to

feed the cooker using a suitably rated cable.

Where a hob is fitted adjacent to or over the cooker, a 45 amp Double Pole control

switch should be used to feed both units via separate suitably rated cables.

We recommend a minimum of 4mm

PVC insulated twin and earth cable conforming to

B.S. 6004 for connection of each appliance.

Where a hob is fitted above the cooker the cable connecting the hob to the cooker

control unit must be of 2.5mm

85˚C heat resistant cable to BS6141 table 15

In all cases adhere to routing details (see fig. 5).

This appliance must not be installed over any other appliance that generates heat

such as a plinth heater

Installation

Note: Due to many different types of installation, a mains cable is not supplied with this

product. The installer will fit the correct type and length of cable.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28

Pas de commentaire

Hotpoint S220E Manuel d'utilisateur Page 23