Hotpoint S220E Manuel d'utilisateur Page 27

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 28
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 26
26
Before calling a Service Engineer, please check through the following lists.
THERE MAY BE NOTHING WRONG.
Something Wrong?
Problem
Nothing works.
Slight odour or small amount of
smoke when grill / oven is used
for the first time,
This is normal and should cease after a short period.
Display shows
00..0000
.
Grill does not work, but the Oven
works.
Grill does not work.
Grill keeps turning on and off.
Draught from beneath control
panel.
Timer buzzer/bleeper operates
continually
Check
(a) Check
If you find :-
Display is blank.
Then it is likely that there is no electricity supply to your oven.
Check: (i) That the main cooker wall switch is turned on.
(ii) Check other appliances to see if you have a power cut.
(iii) Check the main circuit breaker for the property.
The power supply to your oven has possibly been interrupted, but has
now come back on again. Reset the timer to the correct time of day (see,
Clock / Minute Minder section).
Operating the cooker under the following conditions may cause a safety
device to operate.
(a) Grilling with the door closed - always grill with the door open to the
correct position - see grilling.
(b) Grilling for an excessively long period at maximum setting -
see grilling guide.
(c) Grilling with inadequate ventilation in the cabinet - see installation
instructions.
Check that you have selected a Grill setting on the "Grill" knob (A) - see
grilling page.
When the "Grill" control (A) is operating at less than "4", the grill will cycle
on and off, this is normal and is not
a fault.
A gentle flow of air will be blown from beneath the control panel when
the appliance is used. If the appliance is still warm, this cooling fan may
run on, or restart itself after all of the controls have been turned off.
The fan will stop once the appliance has been cooled. This is normal and
not
a fault.
To cancel the Buzzer/Bleeper, press the "-" button.
If you have been through the above list and there is still a problem;
contact Service (see Key Contacts, back page).
Vue de la page 26
1 2 ... 22 23 24 25 26 27 28

Commentaires sur ces manuels

Pas de commentaire