Hotpoint SD97PEI Mode d'emploi télécharger pdf (Page 15)

INSTALLATION

The appliance must be installed only by a qualified

person in compliance with the instructions provided.

The manufacturer declines all responsibility for improper

installation which may harm persons and animals and

damage property.

Important: The power supply to the appliance must be

cut off before any adjustments or maintenance work is

done on it.

Installation of Built-in Ovens

In order to ensure that the built-in appliance functions prop-

erly, the cabinet containing it must be appropriate. The

figure below gives the dimensions of the cut-out for instal-

lation

(N.B.: Installation in compliance with the consumption

declaration)

under the counter or in a wall cabinet unit.

In order to ensure adequate ventilation, the back panel of

the cabinet unit must be removed. Installing the oven so that

it rests on two strips of wood is preferable. If the oven rests

on a continuous, flat surface, there must be an aperture of at

least45x560mm.

The panels of the adjacent cabinets must be made of heat-

resistant material. In particular, cabinets with a veneer

exterior must be assembled with glues which can with-

stand temperatures of up to 100 °C.

In compliance with current safety standards, contact with

the electrical parts of the oven must not be possible once

it has been installed.

All parts which ensure the safe operation of the appliance

must be removable only with the aid of a tool.

For the correct centring of your appliance, position the 4

tabs on the sides of the oven in correspondence with the

4 holes on the perimeter of the frame. In particular, if the

cabinet side panel:

• is 20 mm thick: the removable part of the tab must be

removed (Fig. A);

• is 18 mm thick: use the first groove, which is factory-

set (Fig. B);

• is 16 mm thick: use the second groove (Fig. C).

Fig. A Fig. B

Fig. C

To fasten the oven to the cabinet, open the door of the

oven and attach it by inserting the 4 screws (supplied with

the appliance) into the 4 holes located on the perimeter of

the frame.

560 mm.

45 mm.

595 mm.

24 mm.

545 mm.

5 mm.

567 mm.

23 mm.

593 mm.

45 mm.

558 mm.

N.B.: Installation in compliance with the consumption declaration

595 mm.

24 mm.

545 mm.

5 mm.

567 mm.

23 mm.

575-585 mm.

558 mm.

595 mm.

45 mm.

min.

45 mm.

min.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire

Hotpoint SD97PEI Mode d'emploi Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires de cuisine et de ménage Hotpoint SD97PEI