Hotpoint 50cm Electric Cooker HUE52G Manuel d'utilisateur télécharger pdf (Page 4)

WARNING – THIS APPLIANCE MUST BE EARTHED.

Electrical connection

Electric cookers come without a power supply cable.

The cooker is designed to operate on an electricity

supply which conforms to the electrical data shown

on the Rating Plate. Some cookers can be connected

to the mains only after removing the back panel of the

cooker itself with a screwdriver*.

N.B.: the following installation procedure must be

carried out by a qualified electrician. The electrical

installation must comply with the IEE Regulations,

Building & local By-Lays.

For the installation of the feeding cable carry out the

following operations:

1 Open the terminal board by inserting a

screwdriver into the side

tabs of the cover. Use

the screwdriver as a

lever by pushing it down

to open the cover (see

diagram).

2 Loosen the cable

clamp screw and

remove it, using a

screwdriver as a lever

(see figure).

3 Slacken the wire

contact screws L-N-

, then fasten the wires

under the screw heads,

respecting the colour

code: Black/Blue (N),

Red/Brown (L) and Bare

Wire/Yellow-Green (

 Once the connections have been made, tighten all

the terminal screws fully.

 Fasten the supply cable in place with the clamp

and close the cover of the terminal board.

Moving the Cooker

Positioning the Cooker

150 mm

650 mm

The height of the

cooker can be

adjusted by means

of adjustable feet in

the plinth (900mm

- 915mm). Adjust

the feet by tilting

the cooker from the

side. Then install the

product into position.

NOTE: This appliance

must not be fitted on a

platform.

The cooker is

designed to fit

between kitchen

cabinets spaced

500mm apart. The

space either side

need only be sufficient

to allow withdrawal

of the cooker for

servicing. It can be

used with cabinets

one side or both as

well as in a corner

setting. It can also be

used free-standing.

Adjacent side walls

which project above

hob level, must not be

nearer to the cooker

than 150mm and

should be protected by heat resistant material. Any

overhanging surface or cooker hood should not be

nearer than 650mm.

Before moving your cooker check that it is cool, and

switch off at the cooker control unit.

Movement of your cooker is most easily achieved by

lifting the front as follows:

Open the grill door sufficiently to allow a comfortable

grip on the underside front edge of the oven roof,

avoiding any grill elements.

Note: Take care in moving the cooker as it is heavy.

Take care to ensure that any floor covering is not

damaged.

Splashplate optional, apply to Parts Department (see

Back Cover for contact number.)

*Concerns certain models only

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

1 2 3 4 5 6 7 8 9 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Hotpoint 50cm Electric Cooker HUE52G Manuel d'utilisateur Page 4

Commentaires sur ces manuels