Hotpoint FIT 804 H OW HA Guide de l'utilisateur télécharger pdf (Page 6)

EXTERIOR SURFACES

• Clean the surfaces with a damp microfibre cloth.

If they are very dirty, add a few drops of pH-neutral

detergent. Finish off with a dry cloth.

• Do not use corrosive or abrasive detergents. If any of

these products inadvertently comes into contact with

the surfaces of the appliance, clean immediately with

a damp microfibre cloth.

INTERIOR SURFACES

• After every use, leave the oven to cool and then

clean it, preferably while it is still warm, to remove any

deposits or stains caused by food residues To dry any

condensation that has formed as a result of cooking

foods with a high water content, let the oven to cool

completely and then wipe it with a cloth or sponge.

• Activate the “Diamond Clean” function for optimum

cleaning of the internal surfaces. (If present).

• Clean the glass in the door with a suitable liquid

detergent.

• The oven door can be removed to facilitate cleaning.

ACCESSORIES

• Soak the accessories in a washing-up liquid solution

after use, handling them with oven gloves if they

are still hot. Food residues can be removed using a

washing-up brush or a sponge.

CLEANING THE CATALYTIC PANELS

ONLY IN SOME MODELS

This oven could be equipped with special catalytic

liners that facilitate cleaning of the cooking

compartment thanks to their special self-cleaning

coating, which is highly porous and able to absorb

grease and grime. These panels are fitted to the shelf

guides: When repositioning and then refitting the

shelf guides, make sure that the hooks at the top are

slotted into the appropriate holes in the panels.

To make best use of the catalytic panels’ self-cleaning

properties, we recommend heating the oven to 200°C

for around one hour using the “Convection Bake”

function. The oven must be empty during this time.

Then leave the oven to cool down before removing

any remaining food residues using a non-abrasive

sponge.

Please note: Using corrosive or abrasive cleaning agents,

sti brushes, pan scourers or oven sprays could damage the

catalytic surface and compromise its self-cleaning properties.

Please contact our After-sales Service if you require

replacement panels.

REPLACING THE LAMP

1. Disconnect the oven from the power supply.

2. Unscrew the cover from the light, replace the bulb

and screw the cover back on the light.

3. Reconnect the oven to the power supply.

Please note: Only use 20-40 W/230 ~ V type G9,

T300°C halogen bulbs. The bulb used in the product is

specifically designed for domestic appliances and is not

suitable for general room lighting within the home (EC

Regulation 244/2009). Light bulbs are available from our

After-sales Service.

- If using halogen bulbs, do not handle them with your

bare hands as your fingerprints could cause damage. Do

not use the oven until the light cover has been refitted.

Make sure that the oven has

cooled down before carrying out

any maintenance or cleaning.

Do not use steam cleaners.

Do not use wire wool, abrasive

scourers or abrasive/corrosive

cleaning agents, as these could

damage the surfaces of the

appliance.

Wear protective gloves.

The oven must be disconnected

from the mains before carrying

out any kind of maintenance

work.

CLEANING AND MAINTENANCE

1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire

Hotpoint FIT 804 H OW HA Guide de l'utilisateur Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Fours Hotpoint FIT 804 H OW HA