Hotpoint FK 1039E .20 X/HA Mode d'emploi télécharger pdf (Page 14)

3. Grip the door on the two outer sides and

close it approximately half way. Pull the

door towards you, lifting it out of its slot (see

diagram). To replace the door, reverse this

sequence.

Inspecting the seals

Check the door seals around the oven regularly. If the seals are damaged,

please contact your nearest Service Centre (see Assistance). We recommend

that the oven is not used until the seals have been replaced.

Replacing the light bulb

To replace the oven light bulb:

1. Remove the glass cover of the

lamp-holder.

2. Remove the light bulb and replace it

with a similar one: halogen lamp voltage

230 V, wattage 25 W, cap G 9.

3. Replace the glass cover (see

diagram).

! Do not touch the light bulb directly with your hands.

! Do not use the oven lamp as/for ambient lighting.

Sliding rack kit assembly

To assemble the sliding racks:

1. Remove the two frames, lifting them

away from the spacers A (see gure).

2. Choose which shelf to use with the

sliding rack. Paying attention to the

direction in which the sliding rack is to

be extracted, position joint B and then

joint C on the frame.

3. Secure the two frames with the guide

rails using the holes provided on the

oven walls (see diagram). The holes

for the left frame are situated at the top,

while the holes for the right frame are

at the bottom.

4. Finally, t the frames on the spacers

! Do not place the sliding racks in position 5.

Left

guide rail

Right guide

rail

Direction

of extraction

Troubleshooting

The “Clock button” and the digits on the

display flash.

Problem Possible cause Solution

The appliance has just been connected to the

electricity mains or there has been a blackout.

Set the clock.

A programmed cooking mode does not

start.

There has been a blackout.

Reprogram the cooking mode.

Only the high luminosity “Clock button”

is lit.

The appliance is in standby mode. Press any button to exit standby mode.

The temperature inside the oven is higher

than the suggested value for the selected

mode.

An automatic mode has been selected.

“Hot” appears on the display and

cooking does not start.

Wait for the oven to cool down.

Fan-assisted cooking has been

selected and the food looks burnt.

Positions 1 and 5: the direct heat could cause

temperature-sensitive foods to burn.

We recommend switching dripping pan

positions halfway through cooking.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Hotpoint FK 1039E .20 X/HA Mode d'emploi Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Fours Hotpoint FK 1039E .20 X/HA