Instructions for Installation and Use Built-In Gas Oven SY23To the User:You must read the instructions prior to installing and using the
Adapting to the gas in useIt is possible to use other types of gas by adapting the burner adjustment as follows:Make sure that the oven is not connect
Adjusting the minimumThe oven thermostat is equipped with a by-pass for the minimum.When the type of gas is changed, this adjustment must be adapted a
BEFORE USING THE OVENThese instructions are only valid for the destination countries whose identificationsymbols are shown on the back cover of the ap
The oven is switched on with the DOOR OPEN as follows:press the thermostat knob slightly and turn it anticlockwise to max position;press it again righ
SWITCHING THE GAS GRILL ONTo switch the gas grill on, proceed as follows:open the oven door;press the knob slightly and turn it clockwise to the end,
ELECTRONIC CLOCKThe electronic clock has more than one function:- Displaying the time of day- Switching off the oven with the timerSetting the time of
CLEANING THE APPLIANCE Always allow the appliance to cool down before cleaning to avoida burn injury. Do not use caustic or abrasive agents, coarse wi
REMOVING THE OVEN DOORTo facilitate cleaning inside the oven, the door can be removedas follows:Hinges “A” are provided with two movable bolts “B”. Wh
REPLACING THE OVEN LIGHT (fig. 3)(Not covered by the appliancewarranty)Disconnect the appliance from theelectricity supply, remove the ovendoor (as de
INSTRUCTIONS FOR INSTALLING KNOB GUARDOPEN OVEN DOORINSTALL KNOB GUARD IN SLOTS OF FRONTFASTEN KNOB GUARD ONTO FRONTBY MOVING IT TO THE RIGHTMAKE SURE
DECLARATION OF CE COMPLIANCEThis appliance is in compliance with the following European Directives:93/68 : General regulations90/396 :Concerning gas a
This appliance is marked according to the European directive2002/96/EC on Waste electrical and Electronic Equipment (WEEE).By ensuring this product is
Cod. 12300081940
Improper repair work can cause serious accidents, damage the appliance and equipment as well as impair proper operation.Appliances repaired in technic
All work on the appliances must be carried out by qualified personnel.For maintenance, moving, installation and cleaning of the appliance use suitable
INSTRUCTIONS FOR INSTALLATIONIt is important that all installation procedures be performed by a qualifiedtechnician.After unpacking the oven to connec
It is fundamental to ensure a proper air circulation to the back sideof the appliance; the cut-out dimensions must be observed.If needed, there can be
INSTALLATIONInstallation locationIn order for the gas unit to work properly it is essential that the air necessary for burningthe gas flows into the a
The wires in the mains supply lead are coloured in accordance with the following code:Green and Yellow - EarthBlue - NeutralBrown – Live The connect
CONNECTION TO THE GAS SUPPLYThe supply system must be compliant with the current standards in the country of use. The type of gas for which the oven h
Commentaires sur ces manuels