Hotpoint RGB532 Manuel d'utilisateur télécharger pdf (Page 23)

CARE AND CLEANING

Proper care and cleaning are important so your range

will give you efficient and satisfactory service. Follow

these directions carefully in caring for it to help assure

safe and proper maintenance.

BE SURE ELECTRICAL POWER IS

DISCONNECTED BEFORE CLEANING ANY

PART OF YOUR RANGE.

Broiling Care and Cleaning

CAUTION: DO NOT OPERATE THE BURNER WITHOUT ALL BURNER PARTS AND DRIP PANS

(IF SO EQUIPPED) IN PLACE.

Turn all controls OFF before removing the

burner parts and drip pans (if so equipped).

The burner grates, caps, burner heads and drip

pans (if so equipped) can be lifted off, making them

easy to clean.

For proper ignition, make sure the small hole in

the section that fits over the electrode is kept open. A

sewing needle or wire twist-tie works well to unclog it.

The slits in the burner heads of your range

must be kept clean at all times for an even,

unhampered flame.

You should clean the surface burners routinely,

especially after bad spillovers, which could clog

these openings.

To remove burned-on food, soak the burner heads in a

solution of mild liquid detergent and hot water for 20-

30 minutes. For more stubborn stains, use a toothbrush.

Before putting the burner head back, shake out

excess water and then dry it thoroughly by setting

it in a warm oven for 30 minutes.

Replace the burner caps. Make sure that caps are

replaced on the correct size burner. There is one

small, 2 medium and one large cap.

NOTE: On some models the caps are all the same

size and can be used in any of the 4 needed locations.

The electrode of

the spark igniter is

exposed when the

burner head is

removed. When one

burner is turned to LITE, all the burners spark.

Do not attempt to disassemble or clean around

any burner while another burner is on. An electric

shock may result, which could cause you to knock

over hot cookware.

Grate

Burner cap

Burner head

Drip pan

(on some models)

Electrode

Sealed Burner Assemblies

(on some models)

Burner Heads

(on sealed burners only)

Electrode

Burner Caps

(on sealed burners only)

Lift off when cool. Wash burner caps

in hot, soapy water and rinse with

clean water. You may scour with a

plastic scouring pad to remove

burned-on food particles.

Dry them in a warm oven or with a

cloth—don’t reassemble them wet.

Replace the burner caps.

Make sure that caps are replaced on

the correct size burner. There is one

small, 2 medium and one large cap.

NOTE: On some models the caps

are all the same size and can be

used in any of the 4 needed

locations.

Front of Range

(continued next page)

small

large

medium

small

large

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Hotpoint RGB532 Manuel d'utilisateur Page 23

Commentaires sur ces manuels

Produits connexes et manuels pour Radio Hotpoint RGB532