Hotpoint RGB532 Manuel d'utilisateur télécharger pdf (Page 24)

CARE AND CLEANING

(continued)

CAUTION: DO NOT OPERATE THE BURNER WITHOUT ALL BURNER PARTS AND DRIP PANS

(IF SO EQUIPPED) IN PLACE.

Drip Pans (on some models)

Remove the grates and lift out the drip pans.

Drip pans can be cleaned in a dishwasher or by hand.

To get rid of burned-on food, place them in a

covered container (or plastic bag) with 1/4 cup

ammonia to loosen the soil. Then scrub with a

soap-filled scouring pad if necessary.

When replacing the drip pans, make sure they are in

the correct position.

CAUTION: Do not clean the drip pans in a self-

cleaning oven.

Standard Twin Burners

(on some models)

On models with standard twin burners, the cooktop

lifts up for easy access.

Turn all controls OFF before removing burner

parts and drip pans (if so equipped).

The burner grates and drip pans (if so equipped)

can be lifted off, making them easy to clean.

The holes in the surface

burners of your range

must be kept clean at all

times for proper ignition

and an even,

unhampered flame.

You should clean the surface burners routinely,

especially after bad spillovers, which could clog

these holes. Wipe off surface burners. If heavy

spillover occurs, remove the surface burners from

range. Burners lift out for cleaning. Lift up the

cooktop and then lift out the surface burners.

To remove burned-on food, soak the surface burner

in a solution of mild liquid detergent and hot water.

Soak the surface burner for 20 to 30 minutes. For

more stubborn stains, use a cleanser like Soft Scrub

brand or Bon Ami

brand. Rinse well to remove any

traces of the cleanser that might clog the surface

burner openings. Do not use steel wool because it

will clog the surface burner openings and scratch the

surface burners. If the holes become clogged, clean

them with a sewing needle or twist-tie.

Before putting the surface burner back, shake out

excess water and then dry it thoroughly by setting it in

a warm oven for 30 minutes. Then place it back in the

range, making sure it is properly seated and level.

Check the flame pattern of each burner. If the flames

are “jumpy” (not steady), clean the holes again with a

sewing needle or twist-tie.

Grate

Drip pan

(on some models)

Surface burner

Clean these

holes

thoroughly

on each

burner.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Hotpoint RGB532 Manuel d'utilisateur Page 24

Commentaires sur ces manuels

Produits connexes et manuels pour Radio Hotpoint RGB532