Hotpoint RGB532 Manuel d'utilisateur télécharger pdf (Page 33)

CONNECT THE RANGE TO GAS

Shut off the main gas supply valve before

disconnecting the old range and leave it off until

new hook-up has been completed. Don’t forget

to relight the pilot on other gas appliances when

you turn the gas back on.

Because hard piping restricts movement of the

range, the use of an A.G.A.-certified flexible

metal appliance connector is recommended

unless local codes require a hard-piped connection.

Never use an old connector when installing a

new range. If the hard piping method is used,

you must carefully align the pipe; the range

cannot be moved after the connection is made.

To prevent gas leaks, put pipe joint compound

on, or wrap pipe thread tape with Teflon*

around, all male (external) pipe threads.

*Teflon: Registered trademark of DuPont

PROVIDE ADEQUATE GAS SUPPLY

Your range is designed to operate at a pressure

of 4″ of water column on natural gas or, if designed

for LP gas (propane or butane), 10″ of water

column. Make sure you are supplying your range

with the type of gas for which it is designed. This

range is convertible for use on natural or propane

gas. If you decide to use this range on LP gas,

conversion must be made by a qualified LP

installer before attempting to operate the range

on that gas.

For proper operation, the pressure of natural gas

supplied to the regulator must be between 4″ and

13″ of water column. For LP gas, the pressure

supplied must be between 10″ and 13″ of water

column. When checking for proper operation of

the regulator, the inlet pressure must be at least

1″ greater than the operating (manifold) pressure

as given above. The pressure regulator located

at the inlet of the range manifold must remain in

the supply line regardless of whether natural or

LP gas is being used. A flexible metal appliance

connector used to connect the range to the gas

supply line should have an I.D. of 1/2″ and be

5 feet in length for ease of installation. In Canada,

flexible connectors must be single wall metal

connectors no longer than 6 feet in length.

(continued next page)

Gas Pipe and Electric Outlet Locations

for Models Equipped with Sealed Burners

Gas Pipe and Electric Outlet Locations for

Models Equipped with Standard Twin Burners

⁄2

⁄4

This area allows

for flush range

installation with

through-the-wall

connection of pipe

stub/shut-off valve

and rear wall

120V outlet.

Shortest

connection

from hard pipe

stub location to

range hookup.

This area allows for

flush range installation

with through-the-floor

connection of pipe

stub/shut-off valve.

⁄2

This area allows

for flush range

installation with

through-the-wall

connection of pipe

stub/shut-off valve

and rear wall

120V outlet.

Shortest

connection

from hard pipe

stub location to

range hookup.

This area allows

for flush range

installation with

through-the-floor

connection of pipe

stub/shut-off valve.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Hotpoint RGB532 Manuel d'utilisateur Page 33

Commentaires sur ces manuels

Produits connexes et manuels pour Radio Hotpoint RGB532