Hotpoint FF200TP Manuel d'utilisateur télécharger pdf (Page 11)

WATER LEVEL

MAX

WATER LEVEL

MAX

WATER LEVEL

MAX

ICE CARE tray

The fact that they are situated on the top part of the

freezer drawers ensures greater cleanliness: the ice no

longer comes into contact with the food placed inside

the freezer compartment; furthermore, the dripping of

the water during filling is avoided (a lid to cover up the

hole after filling with water is also provided).

1. Pull out the tray by pushing it up.

Check that the tray is ompletely empty and fill it with

water through the opening provided.

2. Take care not to exceed the level indicated (MAX

WATER LEVEL). Excess water prevents the ice cubes

from dispensing (if this happens, wait for the ice to

melt and empty the tray).

3. Turn the tray 90°: due to the connected compartments

each mould fills with water (

see diagram

4. Close the opening with the lid provided and put the

tray back, placing the top part in the corresponding

housing and allowing it to drop in again.

5. When the ice has formed (minimum time

approximately 8 hours) knock the tray against a hard

surface and wet the outside so that the ice cubes

come loose and take them out through the opening.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Hotpoint FF200TP Manuel d'utilisateur Page 11