Hotpoint H151EWH Manuel d'utilisateur télécharger pdf (Page 5)

Installation

WARNING – THIS APPLIANCE MUST BE EARTHED.

Mains Connection

Your cooker should have been checked to ensure

that the voltage corresponds with your

supply volt

age,

this is stated on the rating plate, which is situated

on the rear panel.

The cooker must be connected by a competent person such as one who is NICEIC

registered contractor to suitable double-pole control unit with a minimum rating of 45A

and a minimum contact

clearance of 3mm, which should be fitted adjacent to the cooker, in accordance with IEE

regulations. The control unit must be within 2 metres of but not directly above the

appliance and should be easily accessible in the event of an emergency.

The power supply cable should conform to B.S.6004 with a conductor size of 6mm

minimum.

Access to the mains terminals is gained by removing the rear access cover. The mains

cable must pass through the cable clamp adjacent to the terminal block. Sufficient cable

should be used to allow the cooker to be pulled out for servicing.

Ensure that the mains cable is routed away from any brackets affixed to the rear panel

and is not trapped to the rear wall when pushing the cooker into position between

cabinets.

Note: If the cooker is to be placed on a base, precautions must be taken to prevent it

from slipping off the base.

Siting the Cooker

The cooker is designed to fit between kitchen cabinets spaced 500mm apart. The space

either side need only be sufficient to allow withdrawal of the cooker for servicing. It can

be used with cabinets one side or both as well as in an angled corner setting. It can also

be used freestanding.

This cooker is a Type X appliance, as such adjacent side walls which project above hob

level, must not be nearer to the cooker than 150mm and should be

protected by heat

resistant material. Any overhanging

surface or cooker hood should not be nearer 650mm.

The height of the cooker can be adjusted by means of adjustable feet in the plinth

(900mm - 915mm). Adjust the feet by tilting the cooker from the side. Then install the

cooker into position.

Moving the Cooker

Before moving your cooker, switch off at the cooker control unit, ensure that it is cool.

Open the grill door sufficiently to allow a comfortable grip on the underside front edge of

the oven roof, avoiding any grill elements.

Radio Interference

This appliance conforms to EN 55014 regarding suppression of radio and television

interference.

Note: Take care in moving the cooker as it is heavy. Take care to ensure that any floor

covering is not damaged.

1 2 3 4 5 6 7 8 9 10 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Hotpoint H151EWH Manuel d'utilisateur Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Petits appareils de cuisine Hotpoint H151EWH