Hotpoint RB526DHWW Manuel d'utilisation et d'entretien Page 15

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 36
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 14
Not all features are on all models.
Not all features are on all models.
Clock (on some models)
To Set the Clock
The clock on your range is powered by the
range itself. No batteries are necessary. The
time is displayed with no timer or audible alarm.
To set the clock, turn the stem left or right.
To clean the clock, see instructions on page 23.
For any repairs, call a qualified service
technician.
The clock must be set to the correct time
of day for the automatic oven timing functions
to work properly. The time of day cannot be
changed during a delayed cooking or a delayed
self-cleaning cycle.
Touch the Clock pad twice.
For models without a Clock pad:
Hold the + and - pads for 3 seconds.
Touch the + or pads.
If the + or pads are not touched within one
minute after Step 1, the display reverts to the
original setting. If this happens, repeat Step 1
and reenter the time of day.
Touch the Start/On pad until the time of
day shows in the display. This enters the
time and starts the clock.
To check the time of day when the display is
showing other information, simply touch the
Clock pad. The time of day shows until another
pad is touched.
Make sure the clock is set to the
correct time of day.
To Turn Off the Clock Display
If you have several clocks in your kitchen, you
may wish to turn off the time of day clock
display on your range.
Touch the Clock pad once to turn off the
time of day display. Although you will not
be able to see it, the clock maintains the
correct time of day.
Touch the Clock pad twice to recall the
clock display.
For models without a Clock pad:
Touch the Bake and Broil Hi/Lo pads at
the same time until the display shows SF.
Touch the Timer pad. The display will show
ON (Clock display on). Touch the Timer pad
again until the display shows OFF (Clock
display off).
Touch the Start/On pad to leave the
control set in this mode.
NOTE: If the clock cannot be recalled or it
will not stay permanently displayed, the Energy
Saver Mode feature is on. To turn the feature
off, see the Energy Saver Mode section.
15
12
6
39
Using the clock and timer. GEAppliances.com
Vue de la page 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

Commentaires sur ces manuels

Pas de commentaire